chassis photo, what do you think about it ?
Discussion
Bonsoir Christophe le breizh, la voiture est très bonne, sans doute!
It's impossible to tell the true state of the chassis without seeing all of it (by separating it from the body), but from what you can see it looks good.
Of interest to others wondering where certain parts of the car are that often get a mention, the first photo shows the location of the fuel pump. Photo 3 shows the access hatch to the bellhousing (rubber bung missing), the troublesome 100A fuse, the clutch slave cylinder and that the car has been grounded (not unusual) judging by the grazing on the exhaust pipe and the part of the sump adjacent the drain plug.
It's impossible to tell the true state of the chassis without seeing all of it (by separating it from the body), but from what you can see it looks good.
Of interest to others wondering where certain parts of the car are that often get a mention, the first photo shows the location of the fuel pump. Photo 3 shows the access hatch to the bellhousing (rubber bung missing), the troublesome 100A fuse, the clutch slave cylinder and that the car has been grounded (not unusual) judging by the grazing on the exhaust pipe and the part of the sump adjacent the drain plug.
If you're intending to keep the car then it is time to work is on the outriggers. There are signs of rot under the coating where the centre tube meets the outrigger. In my experience this indicates that there will be a lot of flaking in the area just above the body mounting plates. At this time I would say you only need to clean the area fully with tooth brushes and other soft devices then get lots of waxoyl in there. You should also remove any road muck from the outrigger tops at the wheel arches and then waxoyl the outrigger tops. Repeat annually and that should buy you many years extra chassis life.
I notice from the pic's there is not photo of the outriggers behind the front wheels, [near the cill], as these are usually the worst, i would wonder why. Generally from what i car see it looks pretty good and at least they have used the right waxoyl and not the black sticky stuff.
By the way Andy, are you sure there be a rubber cover over the gear box housing? I do not have one either? I have had other cars without one to! just like to know if i should be getting one.
By the way Andy, are you sure there be a rubber cover over the gear box housing? I do not have one either? I have had other cars without one to! just like to know if i should be getting one.
That photo confirms my comments above. It is possible to view the outrigger tops by removing the road wheels to make room for your head. It's worth doing as that's where you'll find the answer to the chassis condition.
It's worth noting the flaking on the drop link hanger. This is the normal state for flat section and definitely worth spending time removing the flake, rust proofing and coating. Not as important as the chassis as these parts are relatively easy to remove and replace but still worth some work to lengthen their life.
It's worth noting the flaking on the drop link hanger. This is the normal state for flat section and definitely worth spending time removing the flake, rust proofing and coating. Not as important as the chassis as these parts are relatively easy to remove and replace but still worth some work to lengthen their life.
See if they will send you a pic of the front outriggers nearest to the front wheel, i am not sure if you are aware that the pic you have just posted is of the rears?
When you go and look, if poss. try to get it put on a ramp so you can get a good look, and take a screwdriver with you so you can have a good poke at the outriggers. If you find any sign of a hole underneath it will be much worse on top. If this is the case do be put off too much as it can be fixed, just make sure your offer reflects this.
By the way how old is the car and what mileage? I would guess around 30,000 miles, going on the condition of my outriggers.
When you go and look, if poss. try to get it put on a ramp so you can get a good look, and take a screwdriver with you so you can have a good poke at the outriggers. If you find any sign of a hole underneath it will be much worse on top. If this is the case do be put off too much as it can be fixed, just make sure your offer reflects this.
By the way how old is the car and what mileage? I would guess around 30,000 miles, going on the condition of my outriggers.
Chassis looks good to me. Light surface rust which I'd spend some time getting stripped and painted but from what I can see in the pics it looks solid overall. Just make sure you get in there and don't feel scared to poke around with a screwdriver or scrape away the surface rust to see just how deep it is.
Take a wood chisel with you & have a good old scrape at the corners with the front edge of the chisel. You'll be amazed what you'll uncover. I'm not saying don't buy it, just be prepaired to have bits replaced as & when. Mine's probably a bit worst than that but I'll probably get the drivers side replaced this year & go from there. The rest of the chassis looks great & if it's a good healthy car go for it. I don't think you'll get anything significantly better than that TBH. 
Gassing Station | Chimaera | Top of Page | What's New | My Stuff










Used it on all my Tiv's. As soon as you hit the good stuff it's fine. Very honest tool by hand. 