popping from fuel tank
Discussion
When other people have had this issue ther has been various threads about the fuel pump pulling a vacuum, carbon canisters being blocked, purge valves not purging.
None of which I fully understand but a serach on these thinks may help.
I believe some people have resorted to cutting sections of the cap seal out or drilling a vent hole. I would have thought there was a fuel vapour issue associated with this action.
My tank has the standard cap and does pop occassionally, usually when it's low on fuel. I tend to treat it as an audible low fuel warning.
None of which I fully understand but a serach on these thinks may help.
I believe some people have resorted to cutting sections of the cap seal out or drilling a vent hole. I would have thought there was a fuel vapour issue associated with this action.
My tank has the standard cap and does pop occassionally, usually when it's low on fuel. I tend to treat it as an audible low fuel warning.
It is the tank collapsing slightly as the air can not get into it to replace the fule last enough.
There is a carbon canister in the front passenger wing (behind an access panel) that is the culprit as this "cleanses" the air entering / exiting the tank to an extent. You can either replace it, or simply removing it and giving it a bit of a shake and some tapping should free it up again. To prove this theory try driving about with the petrol cap a bit loose for a tankful and you should find it doesnt happen.
Some people drill a hole in the cap, but this doesnt actually fix the real problem.
Cheers
Matt
There is a carbon canister in the front passenger wing (behind an access panel) that is the culprit as this "cleanses" the air entering / exiting the tank to an extent. You can either replace it, or simply removing it and giving it a bit of a shake and some tapping should free it up again. To prove this theory try driving about with the petrol cap a bit loose for a tankful and you should find it doesnt happen.
Some people drill a hole in the cap, but this doesnt actually fix the real problem.
Cheers
Matt
Edited by M@H on Friday 30th January 11:04
Don't actually miss the obvious, the vent pipes can become kinked / compressed by cable ties where they run down & around the chassis. I'd be tempted to get a joiner and cut/shut the vent pipe just so that you can blow down it (with filler cap off) to check which end is blocked
(its the one that runs under/behind the rad and goes through the inner wing to the carbon cannister)
(its the one that runs under/behind the rad and goes through the inner wing to the carbon cannister)P400PLS said:
snippity..........I believe some people have resorted to cutting sections of the cap seal out ..........snip.
Not a recommended course of action as the MOT tests the cap and seal. If broken/tampered with, its a fail.Do the Spend checks first, or accept that it's a "Feature" of TVRs.
Trev
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


