Hi another new member with a missfire
Hi another new member with a missfire
Author
Discussion

Swanni

Original Poster:

34 posts

214 months

Friday 30th January 2009
quotequote all
Introducing myself, Swanni from Bedfordshire, been watching the forum for a few weeks, great info being posted - thanks to you all. I've a starmist blue 1996 400, beige interior, what a joy, can understand your enthsiasm. Can I ask your help. When cold runs like a dream, when hot and cruising below 3k revs it is fine, then press the loud pedal and it doesn't pick up immediately, after a couple of seconds it clears, picks up and goes, it sounds like it is either choking through over fuelling or lacking power through under fuelling. Alternatively keep it at above 3.5 k and it doesn't seem to happen. Thanks again.

M@H

11,298 posts

303 months

Friday 30th January 2009
quotequote all
I'd give the connection block to the Air Meter (and in fact all the ones in sight) some WD40 for starters, then have the plugleads and distributor on and off too for a clean and inspect - basically just rule out all the little odds and ends that could be affecting the engine before starting on the "heavyweight" suspects (air meter would be my next guess). When did you last change your HT leads?

Cheers,
Matt.

GreenV8S

31,027 posts

315 months

Friday 30th January 2009
quotequote all
When you open the throttle the ECU has to inject an extra dose of fuel to stop the engine leaning out, and it needs the throttle pot to tell it to do that. If the throttle pot isn't working correctly then there will be no transient enrichment and the engine will lean out briefly each time to stab the throttle.

I suggest you disconnect the throttle pot. This should give you a terrible flat spot when you open the throttle. If it does, the throttle pot is clearly doing something and you're looking for another problem. If it doesn't make much / any difference, I'd say you are onto the problem. Obviously you reconnect the throttle pot after running this test!


Swanni

Original Poster:

34 posts

214 months

Friday 30th January 2009
quotequote all
M@H, will give the connectors a squirt of WD40, will clean airflow meter as well, check dizzy cap, HT & plug leads, the reason I am tending towards fuelling is that if the leads were breaking down when hot then would the symptoms not be apparent at differing engine loads? Also it does not sound to be missfiring, more like being starved or over fuelled. Thanks, will check the simple things first as you suggest. Swanni

Swanni

Original Poster:

34 posts

214 months

Friday 30th January 2009
quotequote all
GreenV8, seems like my head will be in it's bonnet this weekend, will let you know how it goes. Swanni

sporty stuff

54 posts

214 months

Sunday 1st February 2009
quotequote all
definetly sounds like plug leads or dizzy cap it would,nt pick up if it was a/m/m some do this when steam cleaned under bonnet

Blues

8,546 posts

250 months

Sunday 1st February 2009
quotequote all
Check that none of the plug caps have twisted round and shorting on the manifold.
I had a similar problem which was fixed this way biggrin

Don1

16,885 posts

239 months

Sunday 1st February 2009
quotequote all
3k is time the map moves to 'open' (IIRC) - mine does the same.

Swanni

Original Poster:

34 posts

214 months

Saturday 4th April 2009
quotequote all
Finally got around to doing some of the things suggested, started with cleaning the stepper motor and AFM - better tick over, next new plugs, new plug shrouds, new blue magnecour leads, new dizzy cap & rotor.

The result?? it now pulls at any rev range, in any gear smoothly and no missfire, the cost just over £200, well worth the investment.

Thanks to you all for your help.