manifold gasket
manifold gasket
Author
Discussion

T_Pot

Original Poster:

2,542 posts

228 months

Friday 30th January 2009
quotequote all
is this a big job? my local garage reckons on 4 to 5 hours, i think that's extreme surely?
says the whole system needs dropping to get to the lower bolts?

GreenV8S

31,027 posts

315 months

Friday 30th January 2009
quotequote all
I assume you mean the exhaust manifold. Are you talking about both sides or just one? Access to some of the lower bolts is absolutely atrocious and even if nothing goes wrong it can take hours. If any of the bolts have seized or strip the threads putting it back together, suddenly it's an even bigger job.

T_Pot

Original Poster:

2,542 posts

228 months

Friday 30th January 2009
quotequote all
GreenV8S said:
I assume you mean the exhaust manifold. Are you talking about both sides or just one? Access to some of the lower bolts is absolutely atrocious and even if nothing goes wrong it can take hours. If any of the bolts have seized or strip the threads putting it back together, suddenly it's an even bigger job.
yes mate the exhaust manifold, and both sides

mb450

429 posts

230 months

Friday 30th January 2009
quotequote all
Mine turned into a 2 month, both heads off nightmare when some of the old bolts sheered. As above really the tops aren't too difficult the lowers can be a pain for access.

daz the plumber

14,997 posts

262 months

Friday 30th January 2009
quotequote all
i had my manifolds off three times , think its better to get them re skimmed before re fitting .i would go for nord lock washers and use a few studs mixed with bolts for easy instalation .beleive me removing them three times was a night mare. i used a little heat on corroded bolts .you need a 4 poster ramp for this job .i would say a full days job .

That Daddy

19,464 posts

252 months

Friday 30th January 2009
quotequote all
Maybe i have been lucky but i have done 2 Chims and 1 griff and they have all been a breeze,1st one takes longer of course and yes its easier on a ramp the right tools help too,if one came in on Monday i would take it on but i would confirm the bolts are not seized 1st though and ARP bolts with the metal gaskets are my choice laugh lucky i guess wink

Edited by That Daddy on Friday 30th January 21:28