Bonnet hinge repair
Bonnet hinge repair
Author
Discussion

Whizz65

Original Poster:

127 posts

241 months

Saturday 14th February 2009
quotequote all
Has anyone repaired the bonnet hinge pin that’s bonded in to the front of the bonnet?

There are two studs which the hinge ball joint attaches to; one of these has come loose in the actual bonnet, any suggestions on a repair as this must have happened to others?
My thought is get a large thin washer, weld a nut to it, run it down the stud and bond it to the bonnet in someway?
Any suggestions / advice would be most welcomed especially on a suitable bonding agent.

Many thanks.

spend

12,581 posts

282 months

Saturday 14th February 2009
quotequote all
Note: I'm not sure if the same applies to the later bonnets, Mine is the early lightweight one with alloy cross bracing;)

Its a little hazy, but...

I took mine right out and re-bedded the metal bracket in the bonnet with a mix of resin / inert filler. Then I drilled the underside and made a small alloy strip to sit under the front lip and used small bolts in place of the rivets.

Can't remember if the 'studs' were just bolts fixed to the bracket or if they were bolts welded to the bracket.

Moral is, I was very happy after making the effort to remove the bracket out of the bonnet and refix it.


450Nick

4,027 posts

243 months

Saturday 14th February 2009
quotequote all
Yes I did this quite recently... Here's what I did:

- Raise bonnet

- Loop some rope through the bonnet holes, up and around the garage roof joists to support it nicely.

- undo allen bolts from car and reverse it away from the bonnet (bonnet left hanging in the same position).

- Support hinges in the correct positions and use lots of pre mixed fibre glass to re-bond the bolts (can't remember if its P38 or P40, but its available from Halfrauds).

- Leave overnight to go hard.

- Push car back up to bonnet, put the allen bolts back in and remove the rope.

- Job's a good'un smile


Done a couple of months ago and its been solid as a rock since then so I'd say its fixed, and is pretty neat too if I may say so myself!

chrispitman

742 posts

285 months

Sunday 15th February 2009
quotequote all
Did the same sort of fix as nick, remove the bonnet the fibre glass part box is hollow I drilled two 1" holes in the box section then you can see the back of the bolt. Get them in place by fitting a nut and washer on the outside and then pour some bonding resin through the hole over the bolt head leave to set then filled the hole I drilled with a platic gromet and refitted.