Discussion
The car has now decided to stall almost every time i dip the clutch? the main culprit as i approach a junction dip the clutch to go into 1st or 2nd and it immediatly trys to stall?
Have cleaned the stepper (taking the spindle out)
Re set the ecu
Throttle pot was set about 6 months ago at .35 volts
Im hoping to borrow another stepper in the week to hopefully rule it out.
Im sure i saw a post a little while back with someone who had the same problem?
AFM readings (if im using the correct wires)
blue/green
red
Ign on 0.57v
Engine running 2.0v
Have cleaned the stepper (taking the spindle out)
Re set the ecu
Throttle pot was set about 6 months ago at .35 volts
Im hoping to borrow another stepper in the week to hopefully rule it out.
Im sure i saw a post a little while back with someone who had the same problem?AFM readings (if im using the correct wires)
blue/green
red
Ign on 0.57v
Engine running 2.0v
Edited by Meatball on Sunday 15th February 15:49
The AFM reading is a bit high, its normally around 1.7 volts. More importantly make sure you have no air leaks around the plenum base or associated pipework, as its very sensitive to this at idle. Also make sure you allow the ECU to retrim the fuel mixture at idle after a reset. It takes about 20 seconds to do so, and must not be rev'ed during this period.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


