chim in the air!
chim in the air!
Author
Discussion

bjarkes

Original Poster:

122 posts

215 months

Sunday 15th February 2009
quotequote all
What do you guys use to get your cars in the air, so you can put axelstands under the chassis, there not much room down under.

Bjarke

stackmonkey

5,084 posts

280 months

Sunday 15th February 2009
quotequote all
high speed + hump-backed bridge = air

wink

SteveW8975

6,389 posts

215 months

Sunday 15th February 2009
quotequote all
I asked the same question elsewhere on how to clean the chassis.

Put a trolley jack under one corner, jack it up high enough to get an axle stand under it, repeat at each other corner, then jack up each corner further to lift each stand as high as needed.

If the sills are still too low for your trolley jack, drive onto 4 bits of wood to give a little extra clearance.

V8 Animal

6,015 posts

241 months

Sunday 15th February 2009
quotequote all
100 psi in each corner should do itbiggrin

bjarkes

Original Poster:

122 posts

215 months

Sunday 15th February 2009
quotequote all
Hey 100 psi, that a good one, thanks. And Steve is it steady enough to do each corner like that?

V8 Animal

6,015 posts

241 months

Sunday 15th February 2009
quotequote all
As long as you don't go too high at a time no problem.
I use 3x2 under the front wheels helps the jack clear.

f@-pots

204 posts

234 months

Monday 16th February 2009
quotequote all
Just make sure your trolley jack's wheels are free to rotate. It lifts in an arc and will put lateral forces on the car and or stands if the wheels are not able to move. If you plan on getting under the car I'd get her up on the stands then go round each one with the jack and slightly lift it just to make sure the stands are not pre-loaded with any sideways stress. I know it's a bit belt and braces but I've had a car fall on me many years ago having been assured by the 'mate' in question that all was well.....! Yes it hurt like bloody hell !!!

Barreti

6,689 posts

268 months

Monday 16th February 2009
quotequote all
Your axle stands want to be in a place where there is plenty of chassis strength. Whenever possible I try to get mine on the square section where the wishbones attach.
To jack mine up I put a piece of wood full length across the front crossmember and lift it in the middle then shove axle stands under, then fine tune their position.
Never get anywhere under a car with it just on a jack. I've lifted a car off a guy pinned at the ankles to the road by the front rotors. Very messy.

T_Pot

2,542 posts

228 months

Monday 16th February 2009
quotequote all
I use one of these, by far the best thing i have ever bought. i have had it a few years now, when i had my 300zx that was silly low, its also lifted a discovery td5 with no effort too


http://www.autoexpress.co.uk/products/products/213...