Outrigger tube size and body plates...
Outrigger tube size and body plates...
Author
Discussion

neal1980

Original Poster:

2,585 posts

270 months

Monday 16th February 2009
quotequote all
This has been covered before but cant find it now...

Im about to replace the outrigger tube does anyone have the size and thickness to use.

Thinking of replacing the steel plates as well that hold the body on, what thickness would be recommended ??

Many Thanks

Neal

Barreti

6,689 posts

268 months

Monday 16th February 2009
quotequote all
Tubes are 38mm Outside Diameter and 1.6mm upwards thickness.
Plates are 3mm and vary in width with the biggest being 80mm (I think)

neal1980

Original Poster:

2,585 posts

270 months

Monday 16th February 2009
quotequote all
THANKS!

That was quick smile would you increase the size maybe 3mm for the outrigger tube to make it stronger??

Neal

Barreti

6,689 posts

268 months

Monday 16th February 2009
quotequote all
One word of advice. Measure everything before you start cutting.
Thats tube length, drop to floor length, position of the seatbelt mount, position of the plates both in toward the square chassis and front to back on the long outrigger tube.
If you measure the plates accurately it will be easier in the long run than trying to get the body lined up properly so you can see where they go.

Barreti

6,689 posts

268 months

Monday 16th February 2009
quotequote all
You could, its down to how good you are at welding - to get the penetration. I had both 3mm and 1.6 but the 3mm stuff looked like tank armour in comparison.