how do i decat my exhaust?
Discussion
should simply unbolt or slide out of exhaust clamps. Its the stubby box. Then get a garage ( or do it yourself) to make up a piece to fit in its place with the same end fittings, but with just a straight through pipe the same diamiter as the rest of the exhaust instead of the cat. Bear in mind you'll have to keep the cat safe as it'll need to go back on at MOT time.
Worth doing tho mind. We had 2 identical elises one decat and one standard, and they decat felt like a completely different car. I believe you get an extra 15bhp+ or maybe more on a chim with a big bore staight through system.
Hope this helps.
Worth doing tho mind. We had 2 identical elises one decat and one standard, and they decat felt like a completely different car. I believe you get an extra 15bhp+ or maybe more on a chim with a big bore staight through system.
Hope this helps.
eddyendo said:
should simply unbolt or slide out of exhaust clamps. Its the stubby box. Then get a garage ( or do it yourself) to make up a piece to fit in its place with the same end fittings, but with just a straight through pipe the same diamiter as the rest of the exhaust instead of the cat. Bear in mind you'll have to keep the cat safe as it'll need to go back on at MOT time.
Not possible with the Chim as the main cat is inside the 'Y piece' and is a bespoke item. Either get one that's already been done to replace it and change it back for MOT time or find a friendly MOT garage. Replacement Y pieces can also be bought from places such as ACT.Edited by locodude on Wednesday 18th February 08:46
On the subject of removing pre-cats, they can be an absolute arse to remove. They're incredibly well fixed in place and surprisingly tough when attacked by the usual 'big chisel' method.
Having removed two yesterday, after much cursing, the easiest method was to use a long masonry drill and basically drill them to bits. Wear a mask though - there'll be lots of dust and instinct tells me that its never going to be good for you to breath in the nasty grey stuff.....
Having removed two yesterday, after much cursing, the easiest method was to use a long masonry drill and basically drill them to bits. Wear a mask though - there'll be lots of dust and instinct tells me that its never going to be good for you to breath in the nasty grey stuff.....
Talkwrench said:
On the subject of removing pre-cats, they can be an absolute arse to remove. They're incredibly well fixed in place and surprisingly tough when attacked by the usual 'big chisel' method.
Having removed two yesterday, after much cursing, the easiest method was to use a long masonry drill and basically drill them to bits. Wear a mask though - there'll be lots of dust and instinct tells me that its never going to be good for you to breath in the nasty grey stuff.....
I did this a week ago and agree with you completely, word for word. Worth doing though, engine is breathing so much better as a result.Having removed two yesterday, after much cursing, the easiest method was to use a long masonry drill and basically drill them to bits. Wear a mask though - there'll be lots of dust and instinct tells me that its never going to be good for you to breath in the nasty grey stuff.....
But hold on, removing cats mean you fail MOT, right? I always thought if you do this you have to be ready once a year to put it back to pass MOT, which means it's actually illegal, right?
Removing pre-cats is another story, MOT is done with a warm engine and pre-cats are there to clean-up the exaust before the engine warms up.
Removing pre-cats is another story, MOT is done with a warm engine and pre-cats are there to clean-up the exaust before the engine warms up.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


