WOO-HOO - We might be getting somewhere!!!
Discussion
Ok, i have managed to replicate my rough running!
I swear blind it runs lovely on hardly any fuel!!!! ie when its about a millimeter or two off the 'E' on the gauge. Smooth revving - exhaust sounds rounded and sweet and power is is excellent. First couple times I thought it was a fluke but did exactly the same again today and yesterday.
When I fill it up any, it drives horrible - What could it be? - anyone know the inside of the tank and fuel system well enough to diagnose what could be going on here? I just did the fuel pressure reg and it didn't help so not that. Fuel pump possibly ???
Ryan
I swear blind it runs lovely on hardly any fuel!!!! ie when its about a millimeter or two off the 'E' on the gauge. Smooth revving - exhaust sounds rounded and sweet and power is is excellent. First couple times I thought it was a fluke but did exactly the same again today and yesterday.
When I fill it up any, it drives horrible - What could it be? - anyone know the inside of the tank and fuel system well enough to diagnose what could be going on here? I just did the fuel pressure reg and it didn't help so not that. Fuel pump possibly ???
Ryan
Edited by debaron on Thursday 19th February 18:57
I think the test is to try it with the cap off or so it doesn't make a seal - having no cap seal would be an MOT fail. Could be to do with the venting / canister system creating a vacuum I guess but as I know nothing about it as a deaf but proud pre cat driver we need another armchair mechanic to contribute...... 

Definitely sound like fuel starvation due to a vacuum in the tank or possibly a pump issue.
I'd try driving a few miles and then opening the filler cap. Listen for a rush of air into the tank.
Then put the cap back on but don't tighten it down and see if any better.
On older cars there used to be a pin hole in the cap that acted as a breather. Not sure if this is the case with the Tiv but worth a look.
I'd try driving a few miles and then opening the filler cap. Listen for a rush of air into the tank.
Then put the cap back on but don't tighten it down and see if any better.
On older cars there used to be a pin hole in the cap that acted as a breather. Not sure if this is the case with the Tiv but worth a look.
Ok well it's not the filler cap. Just been for a hoon around Clifton and up the Portway (adhering to all speed limits of course!) and made no difference with cap on and off. Did seem to feel better going uphill.
Might drain the tank and see what comes out!! An unusually large hunk of s
te may be lurking round my pick up pipe. Any tips on doing this?
Cheers,
Ryan
When was the last time you change the fuel filter.
Also what age is the car, and have the rubber fuel hoses ever been replaced you could have a rubber hose failing possibly colapsing under presure.
Would be worth finding out if there is a pre filter in tank output as the main fuel filter if fitted after the pump.
Also what age is the car, and have the rubber fuel hoses ever been replaced you could have a rubber hose failing possibly colapsing under presure.
Would be worth finding out if there is a pre filter in tank output as the main fuel filter if fitted after the pump.
Ok new fuel filter ready to go on tomorrow. Manifold coolant temp sensor arriving first thing and picked up a new ignition amp to go on too.
I'm getting desperate! Hope something helps with this rough running!!!!
Out of interest did notice that when fuel cap was opened, I have POSITIVE pressure inside the tank - ie fuel vapour comes rushing out. Was definitely positive because having greased the spring inside the filler cap, I now have a deposit of heavy oil around the base of the neck and on opening, I could clearly see the oil move when the gas escaped!
Guess this means my charcoal filter is blocked or something isn't venting properly. Something else to try!!!!!!
Looks like you could have a few problems causing the issue, I would leave the fuel cap loose enough so it can vent either way get the problem fixed then investigate the carbon canister.
The way I checked my carbon canister was find the pin on the ecu connector, this is pulled to gnd to activate the canister solinoid, if you take the pipe off the plenum and blow down it you will have resistance when off and none if the solinoid is on/working properly.
As your changing the fuel filter it maybe worth changing the pipe from the fuel pump to filter and filter to copper pipe. On the other side there is a pipe from copper about where the drive shaft is into the tank. Then at the front above bell housing you have the other two short lengths going to the fuel rail.
The way I checked my carbon canister was find the pin on the ecu connector, this is pulled to gnd to activate the canister solinoid, if you take the pipe off the plenum and blow down it you will have resistance when off and none if the solinoid is on/working properly.
As your changing the fuel filter it maybe worth changing the pipe from the fuel pump to filter and filter to copper pipe. On the other side there is a pipe from copper about where the drive shaft is into the tank. Then at the front above bell housing you have the other two short lengths going to the fuel rail.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


