Discussion
I need to replace one of my sensors according to my fault reader.
Tips on getting old one out do i have to butcher a 17mm dd socket or is there another way?
Also thinking of running the car a bit before attempting it to help break the seal by heating the exhaust don't think wd40 will help much.
Cheers
Tips on getting old one out do i have to butcher a 17mm dd socket or is there another way?
Also thinking of running the car a bit before attempting it to help break the seal by heating the exhaust don't think wd40 will help much.
Cheers
spend said:
Run a grinder up a deep hex socket, only takes 10 mins. I'll be around your area Sat if you want to borrow one. IIRC I gave TCS some new sensors if you need any, don't know if he still has them.
I would like to take you up on your offer and if you have a new one spare i'll take that off you as well pay you of course.PM me for my details.
Cheers dave
Paul
Make sure you smooth the edges off if you take this approach because the high temperature silicone insulation on these wires is very soft. An alternative approach is to get a box spanner, take the terminals out of the housing (unclip very easily with a small screwdriver) and then just feed the wires down the middle of the box spanner.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




