Wanted! your old ECU loom
Wanted! your old ECU loom
Author
Discussion

Bluebottle

Original Poster:

3,498 posts

271 months

Sunday 8th March 2009
quotequote all
Does anybody have an old fried ECU loom they can let me have (beer money waiting)?
I recently bought a Fault Code Reader only to find that, not only do i not have the plug on my loom, I don't even have the female pins and wires at the plug end of the loom.
So I only need the fault code reader plug and 4no. pins outs with a couple of foot of wire still attached to clip into my ecu plug.

Johno

8,593 posts

313 months

Sunday 8th March 2009
quotequote all
I've got my whole Griffith Engine loom sitting in a bag in the garage. I was going to put it in the classifieds.

It has been cut in half as it's the easiest way to get the bung off it to put it onto the new loom.

Make me an offer.


spend

12,581 posts

282 months

Sunday 8th March 2009
quotequote all
I'll give you a tenner Mark, and Hamish can have the wires and diagnostic plugs (there are 2 IIRC). I only want the connectors housings to re-pin ~ they are F expensive in the scheme of things - even the blades are expensive for the timer housings IMHO.

Bluebottle

Original Poster:

3,498 posts

271 months

Sunday 8th March 2009
quotequote all
The rest of the loom would only go to waste if i had it so, if the offer is good for you Johno, I'm happy to get what I need off of Spend.

steve-V8s

2,924 posts

279 months

Sunday 8th March 2009
quotequote all
The connectors I could do with are the brown and white multi pin ones that join the engine loom to the body loom. Oh and a definitive drawing of which wire goes where although I think I have just about figured that out now.

clive f

7,259 posts

264 months

Sunday 8th March 2009
quotequote all
I`ve got some bits that may be of use, let me know what your after, and I`ll get dnb to point out whats what, as I havent the faintest myselfhehe

Bluebottle

Original Poster:

3,498 posts

271 months

Thursday 26th March 2009
quotequote all
Johno YHM

lotusandy

257 posts

302 months

Thursday 26th March 2009
quotequote all
As the loom is now getting chopped up into its component parts I would like to put a bid in for as much of the Lambda wiring as is available, idealy the bit that extends the sensor lead to the sensor + the part of the main loom that the extender plugs into, quite happy to bung £10 or so into the pot for that.

Andy