Heater just blows cold
Heater just blows cold
Author
Discussion

retroptvr

Original Poster:

334 posts

250 months

Friday 13th March 2009
quotequote all
I had a slight coolant hose leak.

Tighten up. Added new coolant to swirl pot, bled off at radiator vent, topped up to nuts, with heater control turned to hot.

Any ideas as to why she's just blowing cold? Please

WazzaL

960 posts

240 months

Friday 13th March 2009
quotequote all
Not sure if it makes a difference, but when I did mine it was switched on as well as on full..


Is there any coolant in the expansion tank? - Should be some. though the exact amount seems to vary.

Edited by WazzaL on Friday 13th March 09:01

retroptvr

Original Poster:

334 posts

250 months

Friday 13th March 2009
quotequote all
Just a smidgen in the expansion tank, seems to only be able to support a level of an inch or so from the bottom and just expels it onto the road if filled any higher.

There seems to be a lack of heater problems in these forums, do I therefore suppose they are generally trouble free?

I was once told, that if your heater goes cold suddenly, then suspect a head gasket failure, but hopefully there are other reasons, airlocked etc. There is no evidence of mayo on the oil filler cap, yet.

Can someone please enlighten.

Edited by retroptvr on Friday 13th March 12:31

BBR

110 posts

230 months

Friday 13th March 2009
quotequote all
I think Wazzal is right. When I changed my coolant I had same issue, so I refilled it, bled it from radiator and then with expansion tank and swirl pot still open I ran the engine, obviously with heater on throughout. I found that air continue to bubble up through swirl pot for quite a while (you need to be constantly top up with coolant via the swirl pot and ensure coolant is in expansion tank). Eventually the air bubbles subsided. I put the tops back on and no problems since.

HTH

spend

12,581 posts

282 months

Friday 13th March 2009
quotequote all
Feel the pipes above your fuse box to see if they get warm. Also check the heater valve is opening whilst you are under there wink

Its pretty obvious how it all works when you eventually get your head upside down in the footwell.

Look at the heights, and you will see why I always advise bleeding with the nose lifted up. The throttle warmer pipes can be used to bleed the heater circuit (stat closed) in adverse circumstances, but that might be an indication of really clogged pipes/matrix/bypass?.

scotty_d

6,795 posts

225 months

Friday 13th March 2009
quotequote all
Must be air still in the system dont be scared to let it run out the bleed screw for a good while to get rid of it

GreenV8S

31,027 posts

315 months

Friday 13th March 2009
quotequote all
Make sure the engine is coming up to temperature and the top hose is hot.

One early symptom of total cooling system failure (say because it's dumped its coolant, or the drive belt has fallen off) is cold air from the heater. So treat that as a potentially big problem until you're sure that the engine actually does have coolant circulating.

retroptvr

Original Poster:

334 posts

250 months

Sunday 15th March 2009
quotequote all
Thanks for this Gents. I will be looking for a hill to park on facing up and plenty of fresh coolant to hand, will let you know the result!