Ignition parts quality
Discussion
Yes, certainly the cap, not so sure about the rotor. I went to the local landy dealer thinking they would have original or at leats good ones but it fell apart in no time, took it back and turns out it was a pattern part. No surprise they fall apart when you look closely at how it is moulded, especially around the contacts. The other concern I had with the pattern parts that were stocked most places I tried was the plastic, it seemed very hard and brittle so bits of it break off and disappear into the dizzy. The genuine ones appear to be a softer plastic.
you can get proper Lucas bits at a good price from http://www.famousfour.co.uk/
dogbucket said:
you can get proper Lucas bits at a good price from http://www.famousfour.co.uk/
Seconded,good guys.So good he said it twice
HI Mark
i have known other car manufacturers to be picky with pattern ignition components Japanese cars in the eighties were especially prone,Toyota,Nissan etc,more the fact that the pattern stuff was crap really rather than the cars being particular,when i was at a Honda dealership we had big problems when some of the older models were fitted with pattern rotor arms(not by us obviously)but that included clutches too,thing is if you look at the Lucas arm its really nothing special just that the pattern arm for the RV8 motor is so sub standard
the caps i have seen have seemed OK though.
HI Mark
i have known other car manufacturers to be picky with pattern ignition components Japanese cars in the eighties were especially prone,Toyota,Nissan etc,more the fact that the pattern stuff was crap really rather than the cars being particular,when i was at a Honda dealership we had big problems when some of the older models were fitted with pattern rotor arms(not by us obviously)but that included clutches too,thing is if you look at the Lucas arm its really nothing special just that the pattern arm for the RV8 motor is so sub standard
the caps i have seen have seemed OK though.Edited by That Daddy on Saturday 14th March 12:23
I wouldn't be too concerned about pattern distributor caps, if the two varieties I've seen are anything to go by, but the rotor arm is a different story. I had a similar problem to blitzracing. The rotor arm appeared to be in excellent condition and had identical dimensions to the original Lucas. But what started out as a misfire culminated in the engine not firing at all. What I discovered was that the spark was passing through the rotor arm itself and grounding via the rotor, hence no spark at the distributor cap electrodes. Simple enough to diagnose once it had failed completely but not so simple whilst it was intermittent.
Ok. I need to change my distributor cap as the lead from the coil must have had a bad joint or something and pretty much vaporised the metal end over a period of time, which also caused damage to the socket in the middle of the distributor cap. I have cleaned it out and made up a new lead and engine runs but I suspect it's not a brilliant repair, especially as I have the shunting problem.
Presume if you change the cap you should change the rotor arm at the same time. Thanks for the famous four link - I used to use them for my Range Rover parts but have avoided them with the TVR as people always say "it's not a Land Rover" and you shouldn't buy parts from them.
Presume if you change the cap you should change the rotor arm at the same time. Thanks for the famous four link - I used to use them for my Range Rover parts but have avoided them with the TVR as people always say "it's not a Land Rover" and you shouldn't buy parts from them.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



