Possible reason for knocking?
Discussion
Hello PHers, I've opened a topic quite a long ago about my engine problem. Topic here. One of the replies pointed to the camshaft movement and I think he was correct. I stripped down the engine today and found that the camshaft has quite a bit endfloat and the cam retainer plate shows uneven wear.
Here's a pic of the retainer:

The question is how to measure the endfloat to order a machined retainer as the current one is uneven on the sides.
Cheers,
wal
Here's a pic of the retainer:

The question is how to measure the endfloat to order a machined retainer as the current one is uneven on the sides.
Cheers,
wal
Was your cam made to use the retainer, if it was just machined down it might be the machining that is causing the problem.
I'd try and measure the surface in situ with a DTI before deciding. Then stick the retainer in the wrong way round and check the float on the end of the cam.
Was oil going through the cam key?
I'd try and measure the surface in situ with a DTI before deciding. Then stick the retainer in the wrong way round and check the float on the end of the cam.
Was oil going through the cam key?
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


