Wheel & Suspension settings
Wheel & Suspension settings
Author
Discussion

tvrlee

Original Poster:

160 posts

242 months

Monday 16th March 2009
quotequote all
Hi all, I've recently put Gaz Gold Pro shocks on my chim, very pleased with them but i now want to make sure that the rest of the car is set up properly, so does anyone know the correct camber, toe and caster settings for a chim? There is a garage local to me with laser alignment and i would like to give him the best settings to work to.

Many thanks for any help

Lee

spend

12,581 posts

282 months

Monday 16th March 2009
quotequote all
Try asking Derek the Gasman, he keeps some geo data that he said was the last from TVR and should be able to advise whats best for you & his dampers.

K4TRV

1,819 posts

283 months

Monday 16th March 2009
quotequote all
From an earlier discussion from Ab shocks:

Decrease toe in and increase camber on the front for trackday stars.

Front
Camber = 0.5 to 0.75 degrees Neg
Toe = 1.5mm overall toe or 12 minutes

Rear
Camber = 1.3 degrees Neg
Toe = 3mm overall toe in or 24 minutes

Trev

tvrlee

Original Poster:

160 posts

242 months

Tuesday 17th March 2009
quotequote all
K4TRV said:
From an earlier discussion from Ab shocks:

Decrease toe in and increase camber on the front for trackday stars.

Front
Camber = 0.5 to 0.75 degrees Neg
Toe = 1.5mm overall toe or 12 minutes

Rear
Camber = 1.3 degrees Neg
Toe = 3mm overall toe in or 24 minutes

Trev
Thats great, thanks Trev!

schmokin1

1,223 posts

243 months

Tuesday 17th March 2009
quotequote all
trev, those toe figures, do I divide by two to set each wheel? ie a 1.5mm toe would be 0.75 per wheel adding to 1.5 total toe in?
cheers
schmo (i'm going to get the fishing line out, do a chassis drop test and check my geo before getting mine going for the summer)

K4TRV

1,819 posts

283 months

Tuesday 17th March 2009
quotequote all
schmokin1 said:
snippity........ do I divide by two to set each wheel? ie a 1.5mm toe would be 0.75 per wheel adding to 1.5 total toe in?...snip
Sounds correct to me - however, comma, you need to ensure you know when the wheel is parallel to the centre line of the car before you set 0.75mm.

Not to the body-work or other reference points that are not necessarily aligned !!

That is the hard bit !!

Regards.

Trev

Ab Shocks

1,686 posts

251 months

Tuesday 17th March 2009
quotequote all
schmokin1 said:
trev, those toe figures, do I divide by two to set each wheel? ie a 1.5mm toe would be 0.75 per wheel adding to 1.5 total toe in?
cheers
schmo (i'm going to get the fishing line out, do a chassis drop test and check my geo before getting mine going for the summer)
Yep, divide total by 2 for wheel toe.

Ab Shocks

1,686 posts

251 months

Tuesday 17th March 2009
quotequote all
spend said:
Try asking Derek the Gasman, he keeps some geo data that he said was the last from TVR and should be able to advise whats best for you & his dampers.
Yep the later data above was issued to take into account modern tyre design.