Stuck oil pressure relief valve
Stuck oil pressure relief valve
Author
Discussion

TVRmuppet

Original Poster:

144 posts

243 months

Monday 16th March 2009
quotequote all
Oil pressure became almost 0 on idle and 60 on revs. Suspected the oil pressure relief valve. Have removed the plug and the spring and the plunger is stuck solid. Its and early car. I believe the bottom plate on the pump can be removed in situ to remove the pump gears and the punger should then be able to force out. I also understand the a design change was brought in to prevent this problem. Has anyone had experience of this and what did you do to rectify. Thanks in advance.
Steve

ROBTVR

208 posts

261 months

Monday 16th March 2009
quotequote all
When mine got stuck i replaced the oil pump base and gears, Bought from RPI engineering (http://www.v8engines.com/engine-9d.htm), easy job to fit, just pack the base and gears full of vaseline proir to assembly, this will help draw the oil back into the pump otherwise you will have trouble getting oil pressure. Vaseline dissolves in hot oil

spend

12,581 posts

282 months

Monday 16th March 2009
quotequote all
The pistons are commonly tight in the bore, so that may not be indicative of failure. If the piston is stuck in it will not relieve pressure - it would have to be stuck 'out' to cause your problem.

No change in design AFIK, but there are aftermarket tadpole versions. Many people have not been so impressed with them either (search for a posting from wedginauld IIRC?)

The dizzy drive gear - oil pump is also a reasonably common point of failure wink


TVRmuppet

Original Poster:

144 posts

243 months

Monday 16th March 2009
quotequote all
Thanks for that I shall remove it tonight. Its an irritation that I could do without as I am trying to get the Spire GTR ready for the summer. Its nearly at rolling chassis state with the ZZR1200 engine about to go in should make the chim feel like an invalid buggy I hope.

TVRmuppet

Original Poster:

144 posts

243 months

Tuesday 17th March 2009
quotequote all
Aha, took of bottom plate and freed of the plunger. However going to get a replacement assembly from Landrover. Dont fancy having no oil pressure again.