Reconditioned brake calipers - recommendations?
Reconditioned brake calipers - recommendations?
Author
Discussion

rolling_thunder

Original Poster:

152 posts

223 months

Monday 16th March 2009
quotequote all
I have a 98 Chim with vented disks but i am not sure who originally supplied them (were they standard?)

However thats an aside - can anyone recommend a supplier for reconditioned calipers? I thought about just replacing the seals but the pistons have rust on them so i need a full recon. I was going to go to Brakes International www.brakesint.co.uk but suddenly thought that perhaps there are cheaper (but still as good) alternatives. Looks like a recon caliper for a vented disk is £79 + vat at their site with a £50 deposit on return of my knacked ones.

Suggestions people?

ta

RT

daz the plumber

14,997 posts

262 months

Monday 16th March 2009
quotequote all
if your changing the fronts i would not bother replacing what you have got , i would contact hansdaal who supplies a fantatic upgrade and the best value for money i could not beleive the difference .he is a member on piston heads .all ariginal ford equiptment and comes with pads .

supplied the kit to Daz and ofcourse the carriers/sliders are in the kit. They came with the NEW calipers. It is a complete kit with small spacers to get the caliper in the centre of the disc. Sold quite a few of those set-ups and never had any fitting problems. Fits perfect. I use the 278 mm disc instead of the 283 Cossie Cosworth disc because the 283 mm disc is slightly too big in diameter and rubs against the slider/carrier and won't run freely. For perfect fitment you should mill it down 2 1/2 mm for perfect alignment with the outside of the brakepad. So no overhang.278 mm disc is (IMHO) the perfect size for the Cossy caliper and pads.

greetings


Edited by daz the plumber on Monday 16th March 19:39

steve-V8s

2,924 posts

279 months

Monday 16th March 2009
quotequote all
Did my fronts on a 98 Griff a while ago and ordered some exchange items from a well know TVR car parts supplier on the basis that I return the old ones. A bit expensive I thought but stood a better chance of getting the right bits so was happy to pay for the knowledge of the supplier. Borrowed a lift at a local garage to do the job. One of the guys looked at the part No on the box and called a local factor for an exchange price. It was a fraction of what I paid. Going to have the rears off next week and hoping that they will be able to reference a number on the casting. Seems to me when a recon calliper is so cheap makes no sense to get a new set of seals. They seem to be a fairly common Ford part.

scotty_d

6,795 posts

225 months

Monday 16th March 2009
quotequote all
I did my full brake system over the winter new seals and pistons and shot blasted and a lick of paint its like night and day fairly easy job to do. had to make a sleeve to fit the pistons and seals in but easy apart from that front are XR4x4, rear cosworth, also new pads discs and braded hoses well worth it and did not cost the earth. This is who i used for seals and pistons good price's


http://www.brakesint.co.uk/

PurpleV8

137 posts

247 months

Monday 16th March 2009
quotequote all
Used these last year for a set of rear calipers with no problems

http://www.biggred.co.uk/

S4CJO

429 posts

290 months

Monday 16th March 2009
quotequote all
If you are intrested Check Here. These are off my 98 450 and were in full working order before I replaced with a Tuscan conversion.