Unusual non-start problem
Discussion
Happened three times now.
After a good run (read engine nice an hot, I get home and need to go out again and the car wont start. Turns over fine (nice and fast), but wont fire.
There is a spark from the king lead and at least 2 plugs (didnt check them all as its bl**dy hot around them). Checked by plugging in an old timing strobe.
I beleive fuel is readily available as there was a very strong smell, and so was probably then flooded.
I tried lots of things first and second time it happened including disconecting ECU.
It started after several hours after just leaving it.
Second time I took it to a well repected TVR specialist and he said the fault code showed an Oxygen sensor problem ( not sure how this showed after I pulled the ECU plug though). He found a bad connetion to the sensor and 'fixed it'.
This time would not start after an hour, and I had to push it into the garage.
How long do you have to wait if you have flooded the engine.
Am I some how causing the engine to flood when starting it, (when hot starting should I use throttle when cranking)
Is using a strobe light any good as an indication of a 'good' spark.
What else can I check tonight when I get home ?
Mind you if it starts, I cant check anything.
I havent touched the ECU plug this time, so I could get some one to put a reader on it I suppose.
Any thoughts any one ?
Please
After a good run (read engine nice an hot, I get home and need to go out again and the car wont start. Turns over fine (nice and fast), but wont fire.
There is a spark from the king lead and at least 2 plugs (didnt check them all as its bl**dy hot around them). Checked by plugging in an old timing strobe.
I beleive fuel is readily available as there was a very strong smell, and so was probably then flooded.
I tried lots of things first and second time it happened including disconecting ECU.
It started after several hours after just leaving it.
Second time I took it to a well repected TVR specialist and he said the fault code showed an Oxygen sensor problem ( not sure how this showed after I pulled the ECU plug though). He found a bad connetion to the sensor and 'fixed it'.
This time would not start after an hour, and I had to push it into the garage.
How long do you have to wait if you have flooded the engine.
Am I some how causing the engine to flood when starting it, (when hot starting should I use throttle when cranking)
Is using a strobe light any good as an indication of a 'good' spark.
What else can I check tonight when I get home ?
Mind you if it starts, I cant check anything.
I havent touched the ECU plug this time, so I could get some one to put a reader on it I suppose.
Any thoughts any one ?
Please
If it pools in the inlet manifold it will adversely affect several pots
even a slight constant dribble could pool quite quickly..
Iffy injectors have been known to run fine at chat, but have caused endemic problems with starting and low throttle running AFIK. Not arguing that that is your problem, just one possibility
If you have sparks and petrol you need to start looking why it isn't going bang! and the EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR but plenty of LR's over the years but its normally when cold.. hot is unusual and normally electrical ?
even a slight constant dribble could pool quite quickly..Iffy injectors have been known to run fine at chat, but have caused endemic problems with starting and low throttle running AFIK. Not arguing that that is your problem, just one possibility
If you have sparks and petrol you need to start looking why it isn't going bang! and the EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR but plenty of LR's over the years but its normally when cold.. hot is unusual and normally electrical ?spend said:
(snip)
EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR
(snip)
I've flooded my 400 Chim quite a number of times. Usually when reversing in our out of our parking spot. The last time was on Feb 3, the day after the big snow and it was cold.EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR
(snip)
I've found that the best way to get a flooded engine to restart is to start the engine on full throttle to allow as much air to pass through the engine and possible and take the extra fuel out. It does pay to make sure your battery is good though!
Got home from work last night and she started. (car not wife ! )
It was misfiring badly but it did start.
I Cleaned the rotor arm up ( very slight corossion pitting)and took all the plugs out and cleaned them up and re gapped them (they were very slightly to wide and very wet and sooty)
Couldnt try firing her up again as it was now midnight.
Could it be just me using the wrong hot start technique and flooding it ?
After a bad flooding would the ECU record something (like the oxgen sensor trying to compensate)and give a fault codelike the garage mentioned last time it happened ?
I have now ordered new plugs, shrouds and coil to be on the safe side.
It was misfiring badly but it did start.
I Cleaned the rotor arm up ( very slight corossion pitting)and took all the plugs out and cleaned them up and re gapped them (they were very slightly to wide and very wet and sooty)
Couldnt try firing her up again as it was now midnight.
Could it be just me using the wrong hot start technique and flooding it ?
After a bad flooding would the ECU record something (like the oxgen sensor trying to compensate)and give a fault codelike the garage mentioned last time it happened ?
I have now ordered new plugs, shrouds and coil to be on the safe side.
Edited by WokingWedger on Wednesday 18th March 10:59
bsdnazz said:
spend said:
(snip)
EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR
(snip)
I've flooded my 400 Chim quite a number of times. Usually when reversing in our out of our parking spot. The last time was on Feb 3, the day after the big snow and it was cold.EFis are buggers once they flood... sure we all have different ways of fixing it, never had it on the TVR
(snip)
I've found that the best way to get a flooded engine to restart is to start the engine on full throttle to allow as much air to pass through the engine and possible and take the extra fuel out. It does pay to make sure your battery is good though!

WW, I would have tried ign amp first ~ that seems to be the classic intermittent failure... I would always advise keeping a spare that you know works, it just saves so much time diagnosing...

Gassing Station | Chimaera | Top of Page | What's New | My Stuff



