Possible Camshaft change
Possible Camshaft change
Author
Discussion

mchenryg

Original Poster:

117 posts

219 months

Friday 20th March 2009
quotequote all
Morning all
I have been having some engine noise after a motorway blast. There is a knocking noise and feels to be miss firing. I am not very mechanical but I know that 1 or 2 of the plug leads are about 330 deg and not 390 deg.
I guess my Chim will need a new camshaft but I have no idea how much this will cost. I have just lost my job and am really concious that this will cost so much.
Does anyone know of a good indie in the Enfield area. I think Barnet will be too expensive.

Thanks guys/galls.

Giles.

lewis_sharman

5,958 posts

222 months

Friday 20th March 2009
quotequote all
I think the general consensus with regards to camshaft change is £500 parts and the same again for labour. The kits are sold by V8 developments among other places

pkitchen

1,747 posts

240 months

Friday 20th March 2009
quotequote all
Why not have a chat with them at Barnet just to see. Martin is a great guy and I am sure he will do his best to help. You also get a good job done. Better to have that peace of mind imo. Good luck. smile

steve-V8s

2,924 posts

279 months

Friday 20th March 2009
quotequote all
I would suggest rather than assuming you need a new cam the first thing to do is get the car to someone with a ”trained ear” that can give at least a basic diagnosis of what the problem is. Ideally they would also have a gas analyser which may reveal what is going on.

A good way of tracking down the source of a noise is a short length of tube, place one end at your ear and then offer the other end up around the engine bay and see where the noise is loudest. From the tone of you post however you may be better seeking advice. If you don’t have a local TVR man then try seeking out a Landrover independent and slip one of the mechanics a fiver for his opinion, chances are he will be familiar with the normal range of engine noises and what causes them on the Chim.

Wildfire

9,951 posts

283 months

Friday 20th March 2009
quotequote all
There are cases of RV8s running over 100, 000 miles on the original cam, they may not be performing at their best but still running.

If it's a misfire I would check out everything else first. My car was misfiring badly and it turned out to be a spark plug extender arcing. You will get a knocking sound if one or more of the cylinders is not firing.

S4CJO

429 posts

290 months

Friday 20th March 2009
quotequote all
Likewise the plug extenders on my 450 I replaced then shortly after a 12000 service a slight missfire checking back through it was one of the extenders not seated correctly. Since the I've had one of these new ones fail which I replaced with one of the originals and it's fine. Also changed the leads for ACT Magnecor.

Re cams yup V8 give Ray a call and he'll talk you through which one would be suitable for your engine and driving requirements or visit

V8 Developments