center vent housing how do you remove it
center vent housing how do you remove it
Author
Discussion

rcarsv

Original Poster:

7 posts

222 months

Sunday 22nd March 2009
quotequote all
Hi dose anybody know how you get the center vent housing out so I can get to the earthing points.

chrispitman

742 posts

285 months

Sunday 22nd March 2009
quotequote all
The eart point are behind the carpet right up under the dash, if you pull the carpet back from under the dash or push the carpet you should beable to feel where the fibreglass cutout is for the bolt, I managed to pull it back enough to get a spanner on but it is very tight as some of the carpet is sandwiched between the body and dash bottom. I would start with the passenger side it's easier and you can follow the Large Negative lead from the battery as it's connected to the bolt.

sylvo

3 posts

221 months

Sunday 22nd March 2009
quotequote all
Hi, you can take out center consul to give you space, then remove dash top section then remove dash lower section this will give you access to earths. Its all a bit of a fiddle but once you have done it, it gets easier. When its all off it gives you a chance to have a tidy up. I think it gives a guide in steve heaths bible for taking dash top off - basically three nuts two on passenger side reached from under footwell and one drivers side same but it is a side fitting thread whilst the other two are facing downwards. Replace with wing nuts easier for the future if you have to take off. Any probs email me and I will send you a diagram, martinsylvo@hotmail.com

rcarsv

Original Poster:

7 posts

222 months

Sunday 22nd March 2009
quotequote all
Hi thanks for the replies looks like I could be in for some fun.