Front Stub Axle Nut
Front Stub Axle Nut
Author
Discussion

Chassis 33

Original Poster:

6,194 posts

313 months

Wednesday 25th March 2009
quotequote all
A bit of help please folks...I'm trying to replace the front bearings on the Chim, I have the 41mm socket and 3/4" drive breaker, I know that the front drivers side is reverse thread, however I'm damned if I can lock the hub up sufficiently to break the load on the nut. Ive no brakes at present so cant get a willing volunteer to stamp on the brakes to help, I've a 6ft length of flattened scaffold bar that I've tried bolting to the hub flange but just end up sheering bolts...I'm kinda flumuxed.

Any suggestions?
Regards
Iain

spend

12,581 posts

282 months

Wednesday 25th March 2009
quotequote all
If you have air try a big impact driver?

Uncle Fester

3,114 posts

239 months

Wednesday 25th March 2009
quotequote all
Which car were the hubs from?

That Daddy

19,465 posts

252 months

Wednesday 25th March 2009
quotequote all
Sierra wink have you got heat? try and bolt an old st Ford steel rim onto the hub so you can get some purchase



Edited by That Daddy on Wednesday 25th March 15:52

Chassis 33

Original Poster:

6,194 posts

313 months

Thursday 26th March 2009
quotequote all
Right finally sorted it last night. Old TSW alloy, bolted to the hub, scaffold bar thru wheel and sat in the chassis where the steering rack usually sits, 15stone of greasemonkey stood on the end of a 3/4drive breaker bar. Job done.

Regards
Iain