2 Pack or Powdercoat
2 Pack or Powdercoat
Author
Discussion

CaptDaveRobinson

Original Poster:

42 posts

215 months

Wednesday 25th March 2009
quotequote all
I have finally got my chassis blasted and it is about to go for outriggers to be welded. I am not sure whether it would be better to re-powdercoat it or use a expoy based 2 pack. Any ideas? and where do I get 2 pack from?

TJC46

2,199 posts

237 months

Wednesday 25th March 2009
quotequote all
Hi there i too had the same problem powdercoat or paint? I visited a powdercoat company in sheffield and the guy there was very helpful. In his words powdercoating is quick, efficient and durable on most metals and in most circumstances, but he in his opinion would not reccommend powdercoat on a chassis. Why tvr powdercoated in the first place he could not understand. Mine is a 1997 chim and i have just welded in new outriggers both sides. After bead blasting it was 6 coats in total of epoxy primer, to be finished off in red enamel. Tvr"s attempts at powder coating seem to last on average 10 years i only want to do one "bodyoff" on my chim so two pack epoxy for me. I think an other valid plus for paint is when it chips it can easily be touched up .The chassis itself is awkward to paint, all the cross tubing in the centre section was a nitemare, i suppose this was the thinking behind powdercoating. Its your choice at the end of the day im just telling you what i ended up doing, best of luck which ever way you go, Tom.

Rum Runner

2,349 posts

248 months

Wednesday 25th March 2009
quotequote all
Have a read of this one .
http://www.pistonheads.com/gassing/topic.asp?h=0&a... paint decissions

If you are going down the epoxy route which i have done twice,go to the yacht chandlers. international paints 2 epoxy resin is easier to mix than west and also better suited to colder climate (curing time ).
Galvanising is best but i would not go down the powder coat route, the epoxy will not lift and blister like powder coating.Just chip so in high impact areas use stonechip rubber style paint . Good for wheel arches also bottom of sills etc.

Edited by Rum Runner on Wednesday 25th March 20:09

brian7136

50 posts

212 months

Wednesday 25th March 2009
quotequote all
Powder coating is generally polyester. I have used it on several kit car builds and a TR6 restoration and not found it to be particularly durable. It is not very chip resistant and can be permeable to atmospheric moisture causing rusting underneath, particularly if it is not thick enough, or it is not heated sufficiently to enable the powder to flow and fuse. I would use a two pack brush applied epoxy every time. Only down side is that it doesn't look so smooth and it's labour intensive.

Barkychoc

7,848 posts

235 months

Wednesday 25th March 2009
quotequote all