Emerald EGT and map sensor
Emerald EGT and map sensor
Author
Discussion

hiltonig

Original Poster:

3,153 posts

239 months

Thursday 26th March 2009
quotequote all
Finally Emerald are sending me a working sensor EGT ,anyone set this up in their ECU ?, what settings did you use ?, also I have a map sensor anyone used one on this ECU ?

Edited by hiltonig on Thursday 26th March 22:27

350Matt

3,914 posts

310 months

Friday 27th March 2009
quotequote all
I used to run a MAP sensor for load sensing on my emeralded wedge it worked OK but the TPS gave better throttle response. Plus its far far easier to map a car with TPS

I reverted back to the TPS for the load and used the MAP just for baro correction in the end.

450Nick

4,027 posts

243 months

Friday 27th March 2009
quotequote all
Not got a map sensor (will get one at some point though!), but I do run EGT. To view the current value, go to live adjustments and click on one of the variables in the bottom-right hand corner and change it to EGT. My normal idle is around 400-450 degrees IIRC. At the moment I have the following adjustments:

degrees |enrichment
900 | 0
950 | 5
1000 | 15
1050 | 20
1100 | 30

I had TVR power's SC mapper (Frank) take a look at it and he seemed to think that the numbers were reasonable for an RV8, I haven't checked the temps at detonation yet though so not sure what temp this would occur at. If you find any more info, I'd love to hear!

Edited by 450Nick on Friday 27th March 12:46

hiltonig

Original Poster:

3,153 posts

239 months

Friday 27th March 2009
quotequote all
350Matt said:
I used to run a MAP sensor for load sensing on my emeralded wedge it worked OK but the TPS gave better throttle response. Plus its far far easier to map a car with TPS

I reverted back to the TPS for the load and used the MAP just for baro correction in the end.
just got the EGT from Emerald and will fit tomorrow, yes i think ill use the map sensor for baro correction

450Nick

4,027 posts

243 months

Friday 27th March 2009
quotequote all
Yes I've heard the same about mapping of a map sensor, I'll be getting one just for baro adjustment. Would it monitor boost as well?