Help needed to test modied AFM
Help needed to test modied AFM
Author
Discussion

blitzracing

Original Poster:

6,422 posts

251 months

Saturday 28th March 2009
quotequote all
I have now managed enlarge the standard AFM by 6mm, and recalibrate the internal electronics to give the correct voltage readings for the reduced air velocity, so no re-maps needed. Its been tested on a 5 ltr car and it fuels perfectly, but I think it may also improve the shunting problem, but I need a test car with this fault. Anyone in the Bershire / Wiltshire/Oxfordshire area fancy an afternoons testing?

Mark

Chimjunkie

2,879 posts

242 months

Saturday 28th March 2009
quotequote all
Hi Mark, Been following your progress on this for a while now. Are you going to offer an exchange service on this when all working and tested? I for one would like an enlarged AFM (not got shunting issues though) on my 500. It is Mark Adams chipped and tuned so dont want to upset all this too much. I will be getting him to remap the car in the near future to tie in a few other mods i have done though.

Keep up the good and appreciated work!

blitzracing

Original Poster:

6,422 posts

251 months

Saturday 28th March 2009
quotequote all
I do need to get one tested on the Rollers or engine dyno to see if if actualy produces any extra horsepower, or if its urban myth about how restrictive the AFM is compared to the rest of the inlet tract. The unit is also adjustable so the fueling can be acurately tweaked for full power. I must admit so far it did not appear to make a huge difference on the stock 5ltr on road testing, but its very subjective and its damned hard to hold a 5 ltr flat out on UK roads for any significant time !! The next one I will do will be only 5mm bigger as 6mm just breaks into the internal passages, but its still a significant improvement in flow capacity.