clutch slipping... only 40'000 Miles
Discussion
hello everybody...
bought a chim 500 2 weeks ago. went to pick it up in london and drove it back to switzerland (600miles). already when I picked the car up in london I felt that the clutch was slipping in 4th and 5th. I know that when a clutch is dead, it usually does not last much longer than 100-200 miles to go totally.
Stangely, mine got better the more it was driven. when i flored it in 5th, it was slipping just a little bit. but after it slipped a bit, it is totaly fine. it does not slip at all.
when it is cole again. it will slipp slightly again...
WHAT THE HELL IS IT????
Thank your for your help
bought a chim 500 2 weeks ago. went to pick it up in london and drove it back to switzerland (600miles). already when I picked the car up in london I felt that the clutch was slipping in 4th and 5th. I know that when a clutch is dead, it usually does not last much longer than 100-200 miles to go totally.
Stangely, mine got better the more it was driven. when i flored it in 5th, it was slipping just a little bit. but after it slipped a bit, it is totaly fine. it does not slip at all.
when it is cole again. it will slipp slightly again...
WHAT THE HELL IS IT????
Thank your for your help
It is possible the clutch surface had glassed over and would not give %100 grip and with normal use for a time could come back to normal, another thing that could be possible is that if it has lived in London it could have been used a lot in slow moving traffic, this would shorten the life of a clutch. If you keep having trouble you could try bleeding the clutch system, this would be easy and cheap to do and would then rule out any problem in that area.
Oh, and congratulations.
Oh, and congratulations.
MoreSteam said:
I had the very same thing at 38000 miles. Apparently this is a common milage for the clutch to go. Sorry.
NOOOOOOOOOOOOOO!!!! you won't believe, but my garage said the same. then offered me a new clutch for £ 2'000... No joke!!! 
If I do need a new clutch... what would be the best to buy in your oppinion?`
cheers
Blimey I got 80K out of mine with a few track days and two cannonballs for good measure.
I've only had it replaced because I'm a tart and when having the engine out to make it all nice and shiny it was an extra £200.
40000 mile seems low to me but I guess it will depend on how its been driven.

I've only had it replaced because I'm a tart and when having the engine out to make it all nice and shiny it was an extra £200.
40000 mile seems low to me but I guess it will depend on how its been driven.

doppioexpresso said:
MoreSteam said:
I had the very same thing at 38000 miles. Apparently this is a common milage for the clutch to go. Sorry.
NOOOOOOOOOOOOOO!!!! you won't believe, but my garage said the same. then offered me a new clutch for £ 2'000... No joke!!! 
If I do need a new clutch... what would be the best to buy in your oppinion?`
cheers
. Thats a bit steep. Mine was £650 fitted. It's for a 400HC though, which I believe is a smaller unit. The garage I deal with sourced the same as the original.As already posted above, it could be that the clutch plate is contaminated with oil because it gets better when driving which suggests that the contaminates are being burnt off with use.
It may be the input shaft bearing seal has failed and leaking ATF220 all over the clutch plate which is then burnt off with use. This happened to me and it is fairly obvious when you look under the car and spot the oil dispersed along the length of the chassis.
Look on the bright side, saves wax oiling.
Paul
It may be the input shaft bearing seal has failed and leaking ATF220 all over the clutch plate which is then burnt off with use. This happened to me and it is fairly obvious when you look under the car and spot the oil dispersed along the length of the chassis.
Look on the bright side, saves wax oiling.
Paul
paulathome said:
As already posted above, it could be that the clutch plate is contaminated with oil because it gets better when driving which suggests that the contaminates are being burnt off with use.
It may be the input shaft bearing seal has failed and leaking ATF220 all over the clutch plate which is then burnt off with use. This happened to me and it is fairly obvious when you look under the car and spot the oil dispersed along the length of the chassis.
Look on the bright side, saves wax oiling.
Paul
I like you ;-) the glass IS half full... not half empty....It may be the input shaft bearing seal has failed and leaking ATF220 all over the clutch plate which is then burnt off with use. This happened to me and it is fairly obvious when you look under the car and spot the oil dispersed along the length of the chassis.
Look on the bright side, saves wax oiling.
Paul
how did you solve your problem? just clean it with break cleaner? or did you replace something?
doppioexpresso said:
Don said:
We had to replace the clutch in our Chimaera at about 45,000 miles.
The light that burns twice as bright burns half as long. And all that nonsense.
NOOOOOOOOOOOO!!!!!!!The light that burns twice as bright burns half as long. And all that nonsense.
It really shouldn't cost £2K to fit a new clutch. A few hundred quid, yes, but not two thousand.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


