What to ask - looking at a Chim with 60k help/advice
What to ask - looking at a Chim with 60k help/advice
Author
Discussion

Evo

Original Poster:

3,462 posts

285 months

Sunday 29th March 2009
quotequote all
Hi all,

Seeing as the kids have me up nice and early,

I'm looking at a Chim with 60k on it, If a car has a full TVR history should i be worried about any major differerances with a vehicle that has done 45k, just trying to get my head around buying a car with a few more miles on it.

What should i be looking at more closely, can i do anymore to check condition of the camshafts other than seeing if it hunts on idle, also i may not be able to jack it up so what chassis checks can i do when it's on the ground. I was going down the route of a large tub of swarfega and getting my hands to have a good feel underneath.

Any other mechanical checks?? I've printed off the adive on Chimaera pages for an inital pointer.

All advice greatly appreciated as i'm very nearly back into TVR ownership and cant hold the excitement much longer bouncedriving

Edited to say that if enough enough fellow PH'ers tell me i shoudln't worry abot 45 or 60k i'm buying it hehe

Edited by Evo on Sunday 29th March 07:56

WokingWedger

1,030 posts

236 months

Sunday 29th March 2009
quotequote all
I wouldnt worry about mileage at all. Its all about condition.

Mine has 93K and never had a cam change and pulls like a train

Evo

Original Poster:

3,462 posts

285 months

Sunday 29th March 2009
quotequote all
Thats want i want to hear yes , I know i'll have to spend money on whatever i buy, just want to hear peoples opinions on whether there any more inherent problems likely with a car thats done 60k (my mental limit was 45k)especially if the car has been fully serviced through it's life, whats the best way to test the clutch, 4th gear low revs and accelerate??

Edited by Evo on Sunday 29th March 08:26

WokingWedger

1,030 posts

236 months

Sunday 29th March 2009
quotequote all

My car had its first clutch change that I know of at 90K (and I have history and have spoken to the owner before last -who put most of the miles on).

I suppose it all depends on how the car has been used.

Lots of in town short journeys or motorway miles.

Also cars that only get used once a week or even once a month may get through a cam quicker due to the oil draining off prior to every start.

Most of the miles on my car were put on when it was used as daily transport.

dogbucket

1,256 posts

232 months

Sunday 29th March 2009
quotequote all
Yes clutch slippage is most noticeable in 4th and 5th.

Forget about the mileage, most of the main problems are age related and how it has been stored/looked after. Even things like cam wear are so variable in terms of the history of the car, and unfortunately that one is hard to spot as the RV8 is very good at hiding it.

and take a small mirror to look at the outriggers if you cannot get underneath.

Edited by dogbucket on Sunday 29th March 09:18

Makem

156 posts

213 months

Sunday 29th March 2009
quotequote all
Ensure the chassis is in good condition. You can always get it up in the air if needs be by giving the local garage a couple of quid to borrow their ramp.

Red V8

873 posts

258 months

Sunday 29th March 2009
quotequote all
This site is a great read before you go looking..

http://www.chimaerapages.com/resources_buyers.php

TJC46

2,199 posts

237 months

Sunday 29th March 2009
quotequote all
CHASSIS, CHASSIS, CHASSIS. Is it a private sale or from a car dealer? either way get it up on ramps at a garage and inspect closely before you commit to buy. Mine is a 1997 chim 50 thousand miles in stunning condition till i got underneath. Both outriggers were coroded, both front lower wishbones had some corrosion. I knew what i was buying and purchased the car anyway. Have a good poke around with a screwdriver, its unbeleivable what can lie hidden under waxoil,underseal and paint. Use the search and type in bodylift to view my car and its chassis as purchased and after welding etc. Im not trying to scare you off, just be very aware of how bad some cars can be only being 10 years old/ The chassis reweld/repair is, unless you D.I.Y one of the most expensive jobs to do. Now after all that doom and gloom, good luck with your search/purchase, Tom. soapbox

daz the plumber

14,997 posts

262 months

Sunday 29th March 2009
quotequote all
the difference between a 60000 mile car and 45000 car is 15000 miles !

Evo

Original Poster:

3,462 posts

285 months

Sunday 29th March 2009
quotequote all
Well, well , well, thanks for the advice.

Looked fine until I got underneath with a LED inspection lamp and my fingers went in with my finger nails - didn't even get to the screwdriver. The front drivers side outrigger had a hole about 5ml across a 3rd of the way round on the join..........needless to say I walked away.

Was gutted, as had my money in the boot and expectations of putting her on my drive tonight - booo hhoo.

I made the right decisions though ..............didn't I ??????

On the upside the owner now knows he has a hole in the outrigger.

The car was also Rosso pearl and was faded - which I could have lived with and had a respreay in time ! and the windscreen had tape on it which was hiding it was delaminating !

I would rather get an older sounder car ! The moral of this story is age has no relevance, its all about condition as this was a 97 car .


TJC46

2,199 posts

237 months

Sunday 29th March 2009
quotequote all
budget in for a new windscreen when you search most have some delamination at some time.Dont be too down you will get one eventually,any you are seriously interested in,post the details on here,i,e DOES ANYONE KNOW THIS CAR etc that way you may get a proper history of what your interested in.

lifebegins@400

217 posts

231 months

Monday 30th March 2009
quotequote all
Evo said:
Well, well , well, thanks for the advice.

Looked fine until I got underneath with a LED inspection lamp and my fingers went in with my finger nails - didn't even get to the screwdriver. The front drivers side outrigger had a hole about 5ml across a 3rd of the way round on the join..........needless to say I walked away.

Was gutted, as had my money in the boot and expectations of putting her on my drive tonight - booo hhoo.

I made the right decisions though ..............didn't I ??????

On the upside the owner now knows he has a hole in the outrigger.

The car was also Rosso pearl and was faded - which I could have lived with and had a respreay in time ! and the windscreen had tape on it which was hiding it was delaminating !

I would rather get an older sounder car ! The moral of this story is age has no relevance, its all about condition as this was a 97 car .
To further reinforce the mileage arguement for you, I am on 73000 now with original cam and chassis outriggers (95N plate). On the subject of the latter, I wouldn't necessarily be put off by a car which has chassis corrosion problems as long as you factor it into the price. There are various specialist companies now, Sportomotive and Orfords being examples, that can repair outriggers one corner at a time or replace in entirety for sensible three figure sums - these of course are in-site repairs, not body off. Hence, if you find a car which otherwise ticks all the boxes, there's nothing wrong with going for a full on haggle, gently pointing out to the vendor what it's going to cost to put right. If they're keen to sell you may reduce the price sufficiently to accommodate the necessary repairs

Andy

Red V8

873 posts

258 months

Monday 30th March 2009
quotequote all
Evo said:
Well, well , well, thanks for the advice.

Looked fine until I got underneath with a LED inspection lamp and my fingers went in with my finger nails - didn't even get to the screwdriver. The front drivers side outrigger had a hole about 5ml across a 3rd of the way round on the join..........needless to say I walked away.

Was gutted, as had my money in the boot and expectations of putting her on my drive tonight - booo hhoo.

I made the right decisions though ..............didn't I ??????

On the upside the owner now knows he has a hole in the outrigger.

The car was also Rosso pearl and was faded - which I could have lived with and had a respreay in time ! and the windscreen had tape on it which was hiding it was delaminating !

I would rather get an older sounder car ! The moral of this story is age has no relevance, its all about condition as this was a 97 car .
Very much the right decision... IMHO

Zippee

14,157 posts

265 months

Monday 30th March 2009
quotequote all
Evo said:
Well, well , well, thanks for the advice.

Looked fine until I got underneath with a LED inspection lamp and my fingers went in with my finger nails - didn't even get to the screwdriver. The front drivers side outrigger had a hole about 5ml across a 3rd of the way round on the join..........needless to say I walked away.

Was gutted, as had my money in the boot and expectations of putting her on my drive tonight - booo hhoo.

I made the right decisions though ..............didn't I ??????

On the upside the owner now knows he has a hole in the outrigger.

The car was also Rosso pearl and was faded - which I could have lived with and had a respreay in time ! and the windscreen had tape on it which was hiding it was delaminating !

I would rather get an older sounder car ! The moral of this story is age has no relevance, its all about condition as this was a 97 car .
Yes you made the right decision. Theres loads for sale and not all are rust buckets.
Rosso pearl is nice but a bugger when it fades and any ding will often mean a full respray due to touching in difficulties.
As for the windscreen thats a very common problem and IMHO not anything to worry about until it goes over the black area.