Is this a stupid question?
Is this a stupid question?
Author
Discussion

nia198

Original Poster:

115 posts

227 months

Sunday 29th March 2009
quotequote all
Basically, how do I replace the boot solenoid?!

I'm pretty sure it needs replacing, as the boot is not opening and the fuse is ok (at least the one the owners manual says if for the boot is ok) . The solenoid should be fairly simple to replace, right?! So, I though I'd get the old one out first and see if the signal was getting to it when I tried to open it. I went out and bought the correct torx tool to get the screws in the boot mechanism off and...

What I see from inside boot - the part that normally connects to the boot lid is what is hanging off the meachanism...


I assumed the blue part was teh solenoid, and that if I took off the whole mechanism It would come free. Pulling the mechanism slightly towards the front of teh car reveals two things...

1 - The blue part that I thought was the solenoid goes back quite deep and ultimately has 2 wires coming out of it (and a third one floating nearby). However, it wont easily come free of the mechanism. I didn't want to force it. Should it come off? If so, in what direction?


2 - On the other side I see 2 steel wires - now I'm wondering if these go to a solenoid somewhere else in teh boot and whether the blue bit is just a sensor for when the boot is open/shut... I am nervous if I pull the lock away froom the back any further that these steel wires will become streched/broken.


So, how do I replace the solenoid?!

TIA.. Nick

Edited by nia198 on Sunday 29th March 16:56


Edited by nia198 on Sunday 29th March 16:56

PurpleV8

137 posts

247 months

Sunday 29th March 2009
quotequote all
The solenoid is to the off side of the catch, between the catch and the light cluster up under the carpet. What you have found is the actuating cable lead to the solenoid. Look under the rubber seal on the outside towards the lights and you should fine 2 screws. They hold the solenoid in place.

PurpleV8

nia198

Original Poster:

115 posts

227 months

Sunday 29th March 2009
quotequote all
PurpleV8 said:
The solenoid is to the off side of the catch, between the catch and the light cluster up under the carpet. What you have found is the actuating cable lead to the solenoid. Look under the rubber seal on the outside towards the lights and you should fine 2 screws. They hold the solenoid in place.

PurpleV8
Got it. Thanks!!! smile

Never would've found that on my own. Still took me a while to see where it was even once you described it. So, back to the blue thing in the lock itself - I always thought it looked a bit underpowered for the job... paperbag What does it do?

Having found it and unscrewed it, it now works again. I guess it must have been a lose connection, so now I'm worried it will do the same another time and lock me out again when I need to get it open and can't do what I did last time. Wondering if I should try to implement some kind of manual override. Anyone done this? If so, can you PM me.

Wish I asked this question before going round 3 DIY shops to buy a torx screwdriver especially to undo the thing! ha ha

Edited by nia198 on Sunday 29th March 20:21