Vacuum tank for brake servo???
Discussion
Just been replacing some vacuum pipes from the plenum on 94 L 4.0HC pre-serp. Found the brake servo hose to be tee'd off. One goes to the servo the other goes to a vacuum tank in front of the radiator(behind grill). Is this an after market mod or was it standard fit at some point? It's definately nothing to do with the purge valve/canister system. I must admit the brakes were rather sharp.
Any help would be appreciated.
Any help would be appreciated.
No, it is very strange. Its just a cylindrical tank with one hose connection to it. There are also three holes in the wing. One for the purge etc one for the servo and the third is for this hose going to the extra tank. The servo and tank hose are tee'd off by the plenum. Has got me a bit baffled as I've never seen this before. I couldn't decide if it was aftermarket because it does look like a TVR installation(ie b
ks to it, we'll just put it here
)
ks to it, we'll just put it here
)Gassing Station | Chimaera | Top of Page | What's New | My Stuff


