Short cap head SS exhaust manifold bolts
Discussion
I will be removing my pre cats soon. Saw these on ebay and thought they might be easier to fit than the standard bolts - what do you think?
http://cgi.ebay.co.uk/ROVER-V8-EX-MANIFOLD-short-C...
Item number: 270265886240
JB
http://cgi.ebay.co.uk/ROVER-V8-EX-MANIFOLD-short-C...
Item number: 270265886240
JB
chrispitman said:
Get a set of ARP bolts as they use a smaller size spanner/socket allows better access also there stainless, I yhink they came from Tim at ACT Performance.
Or Real Steel,get a decent 3/8 spanner & socket to do em up too
never had problems with the bolts coming loose after the initial shake down run nip/up but think i would go with the Nord Lock washers for insurance next time.Edited by That Daddy on Tuesday 31st March 19:41
remember to tighten them after fitting them as I lost 2 of them after manifold swap and it was fitted by a dealer so you never know if your going to lose some so check them !!!!! what ever they fit !!
ps i went for the ARP ones
ps i went for the ARP ones
Edited by hiltonig on Thursday 2nd April 20:32
Edited by hiltonig on Thursday 2nd April 20:34
Edited by hiltonig on Thursday 2nd April 20:34
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



