Timing Marks - Gis a clue !
Discussion
Ok I have managed to contort my body arms and hands enough to get a spanner onto the dizzy clamp and slacken it and retard my timing slightly. It seems to run better (was pinking a little), but I now want to set it up more accurately.
What do the timing marks look like ?
Are they a notch on the periphery of the crank pulley, a scratch on the face, or white paint that has been covered over ?
What exactly am I looking for ?
Also I have read that often they are not in the correct position (cant remember why now), so how do I check this ?
What do the timing marks look like ?
Are they a notch on the periphery of the crank pulley, a scratch on the face, or white paint that has been covered over ?
What exactly am I looking for ?
Also I have read that often they are not in the correct position (cant remember why now), so how do I check this ?
Go to the let hand side of the car and look down between the swirl pot and the block (look through below the Power steering pump on mine) you will see an obvious pointer as part of the casting.
On the pully for timing marks look at the metal behind the pully (between the timing belt pully and the block). Somewhere on this you will find the timing marks. They are lined off (like a ruler)and marked. I think they are marked from 12 deg BTDC to 12 deg ATDC. It is not the obvious notch (cut out square in said metal), I nearly made this mistake!
I found the easiest way to find and mark the correct points with tipex was to stick the car in a high gear and keep nudging on until the marks were visible.
On the pully for timing marks look at the metal behind the pully (between the timing belt pully and the block). Somewhere on this you will find the timing marks. They are lined off (like a ruler)and marked. I think they are marked from 12 deg BTDC to 12 deg ATDC. It is not the obvious notch (cut out square in said metal), I nearly made this mistake!
I found the easiest way to find and mark the correct points with tipex was to stick the car in a high gear and keep nudging on until the marks were visible.
Edited by mattrosersv on Wednesday 1st April 10:01
Hi, I'm about to do the same thing to mine, having replaced the ign amp and coil extenders etc which has stopped the dreaded 'shunting' and smoothed it out a bit I reckon its about time to check the timing. I dont have the figures here with me at the moment so if anyone has some good figures for around 1000 RPM tickover I'd appreciate it .
Nick........................
Nick........................
To check for TDC, either get an old spark plug, remove the copper and put some coat hanger wire down the centre of it; put that into no1 plug hole and as the piston comes up to TDC you'll see/feel the coathanger wire move up, as it moves now again you know you've past TDC.
On pre-serp engineers IIRC there is a metal tab bolted to the timing chest that is the marker for the timing on serp engines its the notch in the ali casting
Edit, cos I decided the link wasn't very good. Set the timing to 8deg BTDC at idle with the vacuum hose disconnected from the dizzy and capped to prevent an air leak into the manifold.
Regards
Iain
On pre-serp engineers IIRC there is a metal tab bolted to the timing chest that is the marker for the timing on serp engines its the notch in the ali casting
Edit, cos I decided the link wasn't very good. Set the timing to 8deg BTDC at idle with the vacuum hose disconnected from the dizzy and capped to prevent an air leak into the manifold.
Regards
Iain
Edited by Chassis 33 on Wednesday 1st April 11:48
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


