Discussion
Driving the car this morning in London, traffic moving fairly swiftly, then engine cuts out, drift to side of road, stop, try restarting and she fires into life straight away. Drive another 200m and engine cuts out again, same as before, go to restart and fires first time. Another 200m and she dies, this time for good. Engine turns over, but no hint of firing.
Can hear fuel pump priming, and checked fuel is pressurising.
Engine turns over so can't be imobiliser?
Virtually entire ignition system was renewed about 1000 miles ago, so new arm, cap, plugs, coil, leads extenders etc.
Anyone any ideas?
Can hear fuel pump priming, and checked fuel is pressurising.
Engine turns over so can't be imobiliser?
Virtually entire ignition system was renewed about 1000 miles ago, so new arm, cap, plugs, coil, leads extenders etc.
Anyone any ideas?
Check the spade male/female connectors in front of the plenum chamber are clean they are tied to the fat loom, mine would not restart when hot random,basically if the switching signal is not sensed from the coil to the ECU then the injectors will not pulse it thinks the engine is not running(you still have spark and fuel pressure to the rail)may not be your problem but worth a try 

Edited by That Daddy on Thursday 2nd April 13:08
That Daddy said:
Check the spade male/female connectors in front of the plenum chamber are clean they are tied to the fat loom, mine would not restart when hot random,basically if the switching signal is not sensed from the coil to the ECU then the injectors will not pulse it thinks the engine is not running(you still have spark and fuel pressure to the rail)may not be your problem but worth a try 
Thanks, will give that a go.
Edited by That Daddy on Thursday 2nd April 13:08
Would these spades be the ones by the ignition amp / coil etc? or others, or just all?
Teetertank said:
That Daddy said:
Check the spade male/female connectors in front of the plenum chamber are clean they are tied to the fat loom, mine would not restart when hot random,basically if the switching signal is not sensed from the coil to the ECU then the injectors will not pulse it thinks the engine is not running(you still have spark and fuel pressure to the rail)may not be your problem but worth a try 
Thanks, will give that a go.
Edited by That Daddy on Thursday 2nd April 13:08
Would these spades be the ones by the ignition amp / coil etc? or others, or just all?
i have never had the same thing happen since cleaning and some maplins silicone grease 
Ok car is now being looked at.
Apparently there is no power on pin 15 of ECU, which should be permanent live - according to Landrover wiring diagram.
Is Chimaera fuse box different to Landrover? Car is P reg 5ltr.
Anyone have a wiring diagram to hand that they could advise or send through?
Apparently there is no power on pin 15 of ECU, which should be permanent live - according to Landrover wiring diagram.
Is Chimaera fuse box different to Landrover? Car is P reg 5ltr.
Anyone have a wiring diagram to hand that they could advise or send through?
Have you checked the fuse off the car and the socket,you can sometimes miss a blown fuse unless its removed from the board,cant comment on what fuse powers what at the moment because i am at work and all my info is at home,sorry cant me much more help
maybe someone will be along soon with the correct info
have you tried swapping over the 2 silver power relays?
maybe someone will be along soon with the correct info
have you tried swapping over the 2 silver power relays?Edited by That Daddy on Thursday 2nd April 18:32
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




I do love a happy ending. Sniffle.
only made that remark cos i am jealous of your Chims interior