Fuel pump not priming help
Discussion
Hi as above took the car out to give it a wash and polish today, started first time did the washing part then started it moved it out the way for my mate to get in to the wash bay went to start it again after i polished it and no fuel pump priming the relay clicks. So i removed the fuel pump and put 12v across it and it is fine. The ground wire is not to healthy but bells through to the relay any ideas?
This happened to me, I found an inline fuse (not in the main fuse box but) one of the loose ones in the wiring loom perched ontop of the battery. A 15 amp blue one as I recall this had blown for no apparent reason I replaced this over six months ago and all still fine. Also dont forget the immobiliser and inertia switch that would be in series with the circuit.
Monkey Boy said:
This happened to me, I found an inline fuse (not in the main fuse box but) one of the loose ones in the wiring loom perched ontop of the battery. A 15 amp blue one as I recall this had blown for no apparent reason I replaced this over six months ago and all still fine. Also dont forget the immobiliser and inertia switch that would be in series with the circuit.
Not noticed this 15A fuse i have the inertia out and the immobiliser is fine as the relay is clicking away. My fuel pump has an inline fuse thats located in the loom that sits on the battery near to the fuel pump relay, check for a bad connection if the fuse is ok. As for the relay its switched on by the ECU the fuse I refer two is on the power/ contact side and would not stop the relay switching. If you suspect the relay swap it with the other one that supplies the sensors.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



