clutch replacement options
Discussion
Hi
still a bit miffed my tvr as after the very expensive service and mot i was told the said garage that the master cylinder was leaking, so 70 quid later replaced that only to discover that its the slave thats leaking so thats to replace as well. so after all this the damn clutch has started slipping. its a 500 with 48k on the clock so i think the mileage is about right
other then say the usual tvr shops can anyone recommend where the best place to get one is
i plan to do this myself at some point soonish, can the box be dropped underneath or does the engine need to shift forward or out completely?
still a bit miffed my tvr as after the very expensive service and mot i was told the said garage that the master cylinder was leaking, so 70 quid later replaced that only to discover that its the slave thats leaking so thats to replace as well. so after all this the damn clutch has started slipping. its a 500 with 48k on the clock so i think the mileage is about right
other then say the usual tvr shops can anyone recommend where the best place to get one is
i plan to do this myself at some point soonish, can the box be dropped underneath or does the engine need to shift forward or out completely?
i went down your route to find the local auto factors did not have a clue .keepaway from re lined clutch plates like (national).the clutch cover is pritty standard but the plate as a fine spline to suit the gearbox .i spent a fortune in the end and got mine from tvr shop (borg and beck ), don`t forget a new clutch fork , well worth replacing .
Did my clutch last year,and, to be honest not a bad job to do.
removed the gearbox from under the car after removing it from
the bell housing.
done it from start to finish on a saturday morning although I
did have use of a vehicle ramp that made the job so much easier.
The only reason the clutch was changed was because it had gone very
stiff & heavy. I fitted a borg & beck clutch kit from memory.
removed the gearbox from under the car after removing it from
the bell housing.
done it from start to finish on a saturday morning although I
did have use of a vehicle ramp that made the job so much easier.
The only reason the clutch was changed was because it had gone very
stiff & heavy. I fitted a borg & beck clutch kit from memory.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


