wheel alinement
wheel alinement
Author
Discussion

MARKS6900

Original Poster:

306 posts

233 months

Monday 6th April 2009
quotequote all
Hi, took my chimaera for a full wheel alinement today after replacing parts of the suspension after it was kerbed, front checked out ok, but the rear was slightly out but we could not figure out how to adjust the lower wishbone to chassis, we undid the nut inside the wishbone and the nut on the other side but the thread going into the wishbone would not move, what is the correct way, thank you.

Red Cabbage

3,606 posts

263 months

Monday 6th April 2009
quotequote all
MARKS6900 said:
Hi, took my chimaera for a full wheel alinement today after replacing parts of the suspension after it was kerbed, front checked out ok, but the rear was slightly out but we could not figure out how to adjust the lower wishbone to chassis, we undid the nut inside the wishbone and the nut on the other side but the thread going into the wishbone would not move, what is the correct way, thank you.
Hopefully you are tackling the right adjuster. It's the big one at the front of the rear lower wishbone. These frequently seize solid, I had to remove my wishbones and clamp the adjuster in a vice with a metal rod inside it to keep it round before releasing it with plenty of WD40.

good luck

MARKS6900

Original Poster:

306 posts

233 months

Monday 6th April 2009
quotequote all
Hi, yes thats the one, was hopeing to do it on the car if poss to save time, but it would not move, so will have to remove, thanks.

MARKS6900

Original Poster:

306 posts

233 months

Tuesday 7th April 2009
quotequote all
Hi, spent most of today removeing both rear lower wish bones to get the adjusters free, car back together ready for another go at 4 wheel alinement.

Red Cabbage

3,606 posts

263 months

Tuesday 7th April 2009
quotequote all
Pretty seized were they?