Electric mirror switch
Discussion
For those with the Mk1 Chimaera and the seperate big black left/right select switch, there is a suitable replacement if it goes duff (which lots seem to do). This may be old news, but I couldn't find it on nay of the forums, hence putting it here.
Go to Farnell components and get a 769 3010 (PRFDD316FBB000) rocker switch. The hole in the door panel will need relieving by about 2mm each end, but other than that it fits and does the job.
Did this on my car last night. Make sure that you note what wire goes where on the old switch as mine bore no relation to the wiring colours in the manual.
Hope this is of use.
Go to Farnell components and get a 769 3010 (PRFDD316FBB000) rocker switch. The hole in the door panel will need relieving by about 2mm each end, but other than that it fits and does the job.
Did this on my car last night. Make sure that you note what wire goes where on the old switch as mine bore no relation to the wiring colours in the manual.
Hope this is of use.
Yup, that's the one. Don't be put off by the picture (which is an example) - scroll down and look at the PDF techncal sheet which will show you the range and ho the code defines the functionality. The code I gave was the correct one.
Note that you will need to remove a couple of mm of the leading and trailing edge of the cutout in the door with a file/dremel as the switch is the same size, but the retaining lugs are bigger - not difficult. Tried it in mine and works perfectly.
J
Note that you will need to remove a couple of mm of the leading and trailing edge of the cutout in the door with a file/dremel as the switch is the same size, but the retaining lugs are bigger - not difficult. Tried it in mine and works perfectly.
J
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


