Balls just mashed a bolt
Discussion
I my usall manner
i used the wrong size spanner and rounded the brass fuel regulator bolt (the FSE one that you plug the gauge into). In my infinate wisdom i then thought i would try the molgrips and have completlty mashed the bolt (i think it was made from cheese).
Any suggestions on how to get the bolt out? theres about 4mm left
i used the wrong size spanner and rounded the brass fuel regulator bolt (the FSE one that you plug the gauge into). In my infinate wisdom i then thought i would try the molgrips and have completlty mashed the bolt (i think it was made from cheese).Any suggestions on how to get the bolt out? theres about 4mm left

these work and a trip down the plumbers merchant for a new plug
http://cgi.ebay.co.uk/EASY-OUT-OUTS-BROKEN-STUD-SC...
http://cgi.ebay.co.uk/EASY-OUT-OUTS-BROKEN-STUD-SC...
Edited by daz the plumber on Sunday 12th April 21:19
daz the plumber said:
these work and a trip down the plumbers merchant for a new plug
http://cgi.ebay.co.uk/EASY-OUT-OUTS-BROKEN-STUD-SC...
Just be careful with those as I had one snap in the bolt I was trying to remove and then it became a battle to get the extractor out before I could get the bolt out. (was a good quality snap-on extractor too so can't blame poor quality extractor)http://cgi.ebay.co.uk/EASY-OUT-OUTS-BROKEN-STUD-SC...
Edited by daz the plumber on Sunday 12th April 21:19
Edited by Tyre_Tread on Sunday 12th April 23:19
If you hsve enough left this is worth a try before using the drill-in type extractor.
http://www.alltoolsdirect.co.uk/draper-12-6-19mm-s...
Alternatively these have got me out of tricky situation:
http://www.kiwiinnovations.com/superwrench.htm
http://www.alltoolsdirect.co.uk/draper-12-6-19mm-s...
Alternatively these have got me out of tricky situation:
http://www.kiwiinnovations.com/superwrench.htm
hibutts said:
If you hsve enough left this is worth a try before using the drill-in type extractor.
http://www.alltoolsdirect.co.uk/draper-12-6-19mm-s...
Alternatively these have got me out of tricky situation:
http://www.kiwiinnovations.com/superwrench.htm
I can recommend the second of these. I have a couple of them and I've managed to use them successfully to get screws out where I've rounded the heads out.http://www.alltoolsdirect.co.uk/draper-12-6-19mm-s...
Alternatively these have got me out of tricky situation:
http://www.kiwiinnovations.com/superwrench.htm
Easyouts work great but make sure you have drilled a large enough hole and this will mimize the risk of snapping the tool off. Splined ones are safer but don't work as well. The real bugger is that these easy outs are made extreemly hard so if you snap one off they can't be drilled out and welding to them is a real pain. Good luck.
I don't suppose you've ever had situations where boiling water works better than a blow torch... Even heat and spot heat have different applications IME;) In this case the even heat (cold) of the freezer is more likely to be effective IMHO. Cleaner, easier and cheaper also ticks the right boxes to boot.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff






