Easter Sunday Service.
Easter Sunday Service.
Author
Discussion

Tyre_Tread

Original Poster:

10,697 posts

247 months

Sunday 12th April 2009
quotequote all
I went into the garage earlier anmd decided I'd finally have a look where the occasional drip of oil was coming from under the Chim.

As I suspected it was the sump drain plud so I thought I'd change the washer. Almost due an oil change anyway and while I'm changing the oil I might as well change the filter.

I then got the Steve Heath Bible out and printed out a service schedule and spent a satisfying afternon working my way through it.

MOT at the end of the month so I'll ask Guglielmi to pick up on anything I've missed such as checking emissions etc.

I've also cleaned up the stepper motor sensor and the crankcase breathers.

Anything else I should be doing while its up in the air?



hiltonig

3,153 posts

239 months

Sunday 12th April 2009
quotequote all
yep check all your manifold bolts for being tight, I lost 2 and was told you have to check them regular

Tyre_Tread

Original Poster:

10,697 posts

247 months

Sunday 12th April 2009
quotequote all
hiltonig said:
yep check all your manifold bolts for being tight, I lost 2 and was told you have to check them regular
Thanks - all tight!

Teetertank

358 posts

218 months

Monday 13th April 2009
quotequote all
Engine mounts.

Found both mine had split in two yesterday. So engine was free to move as it pleased and had attacked the swirl pot neck with vengeance.

From initial inspection only one actually looked knackered, but once engine raised found other to be duff too.

Tyre_Tread

Original Poster:

10,697 posts

247 months

Monday 13th April 2009
quotequote all
Teetertank said:
Engine mounts.

Found both mine had split in two yesterday. So engine was free to move as it pleased and had attacked the swirl pot neck with vengeance.

From initial inspection only one actually looked knackered, but once engine raised found other to be duff too.
Cheers - done - seem OK with no significant movement.

Also checked the advance mech in the dizzy - also seems OK.

End of rotor arm looks pitted but the cap looks new(ish) and the electrodes barley worn.

Teetertank

358 posts

218 months

Monday 13th April 2009
quotequote all
End of my rotor arm looks a little pitted while electordes as new like yours, both were renewed about 1000miles ago. Pitting and slight scorch marks are mainly on one side of arm tip, which I presume is leading edge so fist contact point for spark as it passes electrode.

Barreti

6,689 posts

268 months

Monday 13th April 2009
quotequote all
If you're looking for things to do you could check and top up your Diff oil.
Mine was a good inch down from the filler before I took it in for repair. It will be drained and refilled as soon as it gets back.
If its up on stands now you might as well do it while you have easy(ish) access.

Tyre_Tread

Original Poster:

10,697 posts

247 months

Monday 13th April 2009
quotequote all
Barreti said:
If you're looking for things to do you could check and top up your Diff oil.
Mine was a good inch down from the filler before I took it in for repair. It will be drained and refilled as soon as it gets back.
If its up on stands now you might as well do it while you have easy(ish) access.
scratchchin :looksinSteveheathbookforoiltype:

Changed the 100A fuse as it was looking a bit corroded. New one duly smothered in Vaseline.


Edited by Tyre_Tread on Monday 13th April 10:15