5000 rpm loss of power
5000 rpm loss of power
Author
Discussion

Al 450

Original Poster:

1,390 posts

252 months

Monday 13th April 2009
quotequote all
Hi all, just after some ideas.

I'm 3000 miles into my rebuilt 4.6 and it's loosening up a treat. Car drives very very well and pulls like a train until I get to 5000 rpm then I get a misfire/hesitation and a significant loss of power. There's no point revving it anymore. Obviously something isn't right and it has to be fuelling, air or timing but I'm not sure what.

Spec is more or less new everything, Serp, lightened and balanced, big valve heads, Piper 218 cam and TVR Power chip but no additional mods as such. I know the 218 is not a top end power cam but I'm fairly sure it should rev past 5000?

I think I'll have to send it to the rolling road but any ideas appreciated thanks.

blitzracing

6,422 posts

251 months

Monday 13th April 2009
quotequote all
Strap a test meter with long leads across the black and white wires from one of the lambda probes. Check it reads at least .8 volts DC under full load (Peak power is supposed to be .92 volts on a narrow band sensor). If its below this you are running out of fuel for whatever reason, sounds like it to me.