Removing radiator on '98 450 - tips
Removing radiator on '98 450 - tips
Author
Discussion

Al 450

Original Poster:

1,390 posts

252 months

Tuesday 14th April 2009
quotequote all
Just taken the radiator out of my '98 450 with aircon and as it was a pig of a job thought I'd post some tips for anyone else in the same situation.

- There's no drain plug on the rad apart from the bleed plug at the top so the coolant has to be drained from the bottom hose.

- There's a couple of omissions in the bible about rad removal. Firstly the fan cowls cannot be removed until the rad is lifted as they are bolted onto the underside of the rad.

- Secondly the bible does not mention Air con cars. The rad is bolted to the air con condensor top and bottom. It's not possible to undo the bottom fixings in situ so the whole assembly has to be lifted out. This means depressurising the aircon and unbolting the pipes to the condensor and removing the aircon receiver/drier. The bracket for this and one of the pipes then has to be bent back to clear the front of the car when it's all lifted out.

- Lift the assembly up about 6 inches then the bottom rad cowl fixings can be accessed although these will be very rusty. Remove the fans and then the rad/condensor can be lifted out as one unit.

- Looks like all the fixings will need replacing. I'll post a list of them when I source them. I had a constant tiny leak from one corner and with the rad removed it's clear to see why. It's knackered and all the fins are flaking off. This was only on the front though which is impossible to check with the condensor in the way.

- Took the rad to a specialist and apparently it's standard Range Rover so the recore will be £110. Will be ready in three days.

Hope this helps someone. smash

paulathome

686 posts

249 months

Tuesday 14th April 2009
quotequote all
You have my sympathy, mine is non aircon but getting the rad back in without damaging paint can be a nightmare so I would think yours is far worse. Did you have the grommets at the bottom of the rad where they go into the bodywork, mine were missing which I think caused the failure of the radiator as it was be hanging from the top mounts rather than resting on the rubber grommets. As for the fan cowl bolts they had turned to dust on the bottom of the rad and had to be sheared of with a large pair of mole grips.
While the radiator was out I pulled the fan supply connectors out of their shells and cleaned the spades with emery cloth. Also pulled the fan motors apart and cleaned and oiled all bearing surfaces. Fitted new fan cowl bolts and applied plenty of grease to the threads.
Also fitted new top mounting bobbins as the originals ripped to bits while undoing the nuts.
Good luck with refit.
Paul.

Al 450

Original Poster:

1,390 posts

252 months

Tuesday 14th April 2009
quotequote all
I had one of the rubber grommets, the other is nowhere to be seen so it's either made a bid for freedom or was never fitted.

I've gaffa taped leather and foam to everything that could be damaged so fingers crossed.

I'm now searching for some more grommets. Think these might be them but undertray fixing???

http://www.powerstores.co.uk/?t=si&item=453



paulathome

686 posts

249 months

Wednesday 15th April 2009
quotequote all
I don't think they are the ones for the rad but definatley exhaust mounts , but I got mine from Racing Green, only a couple of quid each from memory.
Paul.