Serp Oil Change - Prime Pump?
Discussion
Going to do Oil + Filter this weekend - Been reading on here about possible zero oil pressure after a change.
What's the best way to avoid having to remove and pack the Oil Pump?
Someone mentioned filling the Oil Filter with oil first but also posted was a recommendation not to!
Mine's a Serp 400 - Is it true Serps suffered less from this problem?
Cheers
Ryan
As above just fill the filter with oil when you change, it should prime pretty quick. When I did an engine rebuild thats all I did. Just blip the revs when you start the engine gets the oil moving quicker and watch the oil warning light goes out after a few seconds, then you should see the oil gauge showing some presure but these are slow.
I think the priming problems with the serp are more if the engine has been stood with no oil or the pump has been dismantled and cleaned. I used a cheap electric drill-driven pump off ebay to force oil up through the oil pressure sender hole. This got the oil pump going after my strip down.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


