Ignition Wiring
Ignition Wiring
Author
Discussion

philmccann

Original Poster:

430 posts

231 months

Wednesday 15th April 2009
quotequote all
Just trying to tidy up the ignition wiring around the coil / amplifier area. Two sets of wires are connected thro' a Lucas connector. Look like resistors or the like, little square block with male spade either side. About 11/2" all in. They are in the line to the coil.
Was just about to lob them when i thought better of it.

What are they and are they required

Cheers

Phil

philmccann

Original Poster:

430 posts

231 months

Wednesday 15th April 2009
quotequote all
Bit more info.

They have Lucas 953066

Simon Says

19,466 posts

252 months

Wednesday 15th April 2009
quotequote all
Dont be tempted to do away with them they are to reduce voltage and they feed back to the ECU so just dont wink without going into the dynamics of this subject thumbup

philmccann

Original Poster:

430 posts

231 months

Wednesday 15th April 2009
quotequote all
Hi there

Measured one at around 7K but the other one seems to be o/c.

Anyone know more??

hoach

49 posts

218 months

Wednesday 15th April 2009
quotequote all
if you disconnect them the engine will not run.

They send an rpm signal to the ECU (pin39) from the coil negative

philmccann

Original Poster:

430 posts

231 months

Wednesday 15th April 2009
quotequote all
The one which is o/c is obviously doing nowt. Should I look to replacing it. If so, where would I get one??