Dumb question about targa window seal
Dumb question about targa window seal
Author
Discussion

myquest

Original Poster:

78 posts

258 months

Friday 17th April 2009
quotequote all
Just received Mk 2 seal kit and worked out how to fit, two questions:

1 Where can I get the counter sunk self tappers? Halfords, B&Q?
2 Which way round does the seal go? Its got a small flat on 1 side and then angles back, does this go against glass or does the glass close against the angled bit?

Thick I know but would save some time if someone can help, a picture would be good.

Thanks

GJR

827 posts

311 months

Saturday 18th April 2009
quotequote all
I'd imagine you'd be able to get the screws from either Halfords or B&Q, although from memory I cannot remember what size they were. Surprised they didn't supply the screws in the seal kit TBH ?!

The seal goes with the angled edge to the outside, I think BB had a nice picture on here of a cross section through the seal/rail/roof edge. I'll have a look.

If the window and roof are not square on to each other you might find that the window meets the seal at one end of the roof but not the other, in which case a thread from a few days back might help.

old topic



ETA: link to pic from TGP's

Edited by GJR on Saturday 18th April 09:28

myquest

Original Poster:

78 posts

258 months

Saturday 18th April 2009
quotequote all
Thanks for help, new seals fitted and virtually all gaps and wind noise eliminated, success!

Thanks again