Peak Torque for a 500, what revs
Peak Torque for a 500, what revs
Author
Discussion

steviegasgas

Original Poster:

417 posts

216 months

Saturday 18th April 2009
quotequote all
Hi, anyone dyno,d a 500? What revs is peak power or torque? Just wonderin on paper when the power is dipping off, cheers.

Blown2CV

31,662 posts

234 months

Sunday 19th April 2009
quotequote all
My reasonably standard 500 turned a max of 280lb/ft at around 3500rpm, but peak is almost even across 3100-4000rpm

steviegasgas

Original Poster:

417 posts

216 months

Sunday 19th April 2009
quotequote all
Cheers for that.

mattrosersv

579 posts

261 months

Monday 20th April 2009
quotequote all
I did have it on the RR as a standard car about three years ago as standardand the torque peaked at around 4250RPM at 295Lbs/Ft with 259BHP but car had a blocked injector at the time.

I had it back on the RR last week, but car now has some mods. Mark Adams best guess chip, ACT trumpets + V8D Steath that I just fitted (hence the recent RR session).

It is making 343 LBS/FT at 4160 RPM.

They also tested the fuelling and this starts to go too lean at 4500 RPM at which point torque drops off fast.

Max HP was 307.3 at 5200 RPM.

I am going to give Mark Adams a call when I get a chance to see if it is possible to do anything further with the fuelling.

I would be interested in any comments on this thread on what is **normal**.


Blown2CV

31,662 posts

234 months

Monday 20th April 2009
quotequote all
I was talking at the wheels, not estimated flywheel figures

Dave 500

7,889 posts

273 months

Monday 20th April 2009
quotequote all
Mine is 302lbs/ft at 3910 smile

Bluebottle

3,498 posts

271 months

Monday 20th April 2009
quotequote all
mattrosersv said:
It is making 343 LBS/FT at 4160 RPM.

They also tested the fuelling and this starts to go too lean at 4500 RPM at which point torque drops off fast.

Max HP was 307.3 at 5200 RPM.
Thats almost exactly the same figures and fuelling issues as my original rebuild gave, with mc1 cam and no other mods.

ETA you could try increasing the fuel rail pressure, but it didn't cure it with mine at 43 psi so I replaced the jets with Bosch redtops. With the Dollar exchange rate at the time worked out cheaper than having the old one cleaned, but you will need to remap it.

Edited by Bluebottle on Monday 20th April 14:21

spend

12,581 posts

282 months

Monday 20th April 2009
quotequote all
The fuel pressure is always a bit of a chestnut hehe Regulator looks at a spot pressure (vacuum) from a point in the plenum. What you really want is the fuel pressure to be raised v a particular injector relative to the pressure in the particular port it is spurting into.. Due to the breathing some ports will be sucking, some blowing & some doing FA... even if you accept that the spot reading from the plenum is the 'average'

One of the reasons that a few of us support the idea of sequential injection - so that you can always inject against a port in the same phase wink