Thought i would just change the oil
Discussion
Well having still not got to the bottom of the ticking on my engine I thought i would try changing to 10/40 oil see if that helped, Then thought while im at it I will paint the rocker covers and plenum.
So first thing this morning I went out to the garage and took the o/s manifold off again
,
and noticed a hairline crack in one of the welds on the 4>1 joint luckily on the outside edge so I could spot it, anyway I have filled the area with gum gum and packed it into the middle of the joint as best i can too so with a bit of luck this will buy me sometime before a more permanent fix is required (just back off holiday so funds are a bit tight at the moment) it doesnt exactly look pretty but hopefully will suffice for now.
Oddly this only took about an hour so I thought i would carry on so firstly remove plenum all well and good till i tried to lift it out
wouldn't go passed mesh at bottom of screen so in the end it was a case of do or die and I now have a nicely bent mesh 
Ok so rocker covers must be easier, well much toolbox searching later i ended up cutting an 8mm ring spanner down to about 2" long and managed to get the N/S cover off without too much bother, so armed with my new tool i go round to O/S
ok so I do need a socket after all, to cut a long story short nowhere near me had one available today so tomorrows job is finding one to get that side off.
So not put off i cleaned up and sprayed the N/S rocker and the plenum and took some solvol to the shiny bits under the bonnet
So with a bit of luck will find a socket tomorrow and get the O/S done too then its just a case of putting the rocker cover and plenum back on and touch wood a shiny ticking free engine bay
DOH oh yes and do the oil change...........
So first thing this morning I went out to the garage and took the o/s manifold off again
,and noticed a hairline crack in one of the welds on the 4>1 joint luckily on the outside edge so I could spot it, anyway I have filled the area with gum gum and packed it into the middle of the joint as best i can too so with a bit of luck this will buy me sometime before a more permanent fix is required (just back off holiday so funds are a bit tight at the moment) it doesnt exactly look pretty but hopefully will suffice for now.
Oddly this only took about an hour so I thought i would carry on so firstly remove plenum all well and good till i tried to lift it out
wouldn't go passed mesh at bottom of screen so in the end it was a case of do or die and I now have a nicely bent mesh 
Ok so rocker covers must be easier, well much toolbox searching later i ended up cutting an 8mm ring spanner down to about 2" long and managed to get the N/S cover off without too much bother, so armed with my new tool i go round to O/S
ok so I do need a socket after all, to cut a long story short nowhere near me had one available today so tomorrows job is finding one to get that side off.So not put off i cleaned up and sprayed the N/S rocker and the plenum and took some solvol to the shiny bits under the bonnet

So with a bit of luck will find a socket tomorrow and get the O/S done too then its just a case of putting the rocker cover and plenum back on and touch wood a shiny ticking free engine bay

DOH oh yes and do the oil change...........Gassing Station | Chimaera | Top of Page | What's New | My Stuff


