Water in the boot
Discussion
tip i heard was put a generous dusting of talc on the top of the seal. shut the door. the contact profile of the seal will be shown on the underside of the bootlid. if there is a section with a very thin/no imprint that is the leaky area. then you can pull up the seal from the lip, pad the lip a bit and push it back down. as the seal will be higher to start with, should squash down a bit firmer. test with hose.
other method is to get in the boot with a torch and get someone you really trust to let you out again(!) to pour water over with you watching. then adjust the seal as above.
hope this helps
schmo
other method is to get in the boot with a torch and get someone you really trust to let you out again(!) to pour water over with you watching. then adjust the seal as above.
hope this helps
schmo
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


