FEA Model of Chimaera structure (as promised to NICK450)
Discussion
Hi, thought everyone might be interested but I originally promised this to Nick.
This is a link to a Subaru analysis but in section 2.5.1.3 there is a reference to the Chimarea model. I haven't tried to get hold of it yet, if it is possible. But its a start.
https://dspace.lib.cranfield.ac.uk/bitstream/1826/...
Cheers
Bob
This is a link to a Subaru analysis but in section 2.5.1.3 there is a reference to the Chimarea model. I haven't tried to get hold of it yet, if it is possible. But its a start.
https://dspace.lib.cranfield.ac.uk/bitstream/1826/...
Cheers
Bob
For those not wanting to go through the PDF...
2.5.1.3 Evaluation of the TVR Chimaera’s Structure. [35]
During an investigation of a TVR Chimaera, Roots[35] demonstrated the use of
computational modelling in the development of roll cage structures to help TVR
resolve an ongoing problem. During this he found that the careful integration of
a roll cage onto the backbone chassis made significant improvements on the
torsional stiffness, by 400%. A non-linear analysis was then used to determine
whether the roll cage would comply with the statutory requirements, which it
appeared to do. These analyses were then followed by quasi-static testing of a
supplied chassis with the roll cage fitted. Upon testing it was found there was a
good correlation in the simulation and test results for strength; however the
initial implicit model by LS-DYNA3D had a closer correlation with the
experimental tests on the vehicle in terms of plastic hinge locations but this may
be due to the mesh used. Roots concluded “applying FEA to an old problem
TVR were suffering from aided in finding a suitable solution.”
2.5.1.3 Evaluation of the TVR Chimaera’s Structure. [35]
During an investigation of a TVR Chimaera, Roots[35] demonstrated the use of
computational modelling in the development of roll cage structures to help TVR
resolve an ongoing problem. During this he found that the careful integration of
a roll cage onto the backbone chassis made significant improvements on the
torsional stiffness, by 400%. A non-linear analysis was then used to determine
whether the roll cage would comply with the statutory requirements, which it
appeared to do. These analyses were then followed by quasi-static testing of a
supplied chassis with the roll cage fitted. Upon testing it was found there was a
good correlation in the simulation and test results for strength; however the
initial implicit model by LS-DYNA3D had a closer correlation with the
experimental tests on the vehicle in terms of plastic hinge locations but this may
be due to the mesh used. Roots concluded “applying FEA to an old problem
TVR were suffering from aided in finding a suitable solution.”
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


