Loose Earthing Point in Chimaera
Loose Earthing Point in Chimaera
Author
Discussion

Vienna TVR

Original Poster:

89 posts

231 months

Monday 27th April 2009
quotequote all
The earthing point in my Chim 4.5 (at passengers side on the transmission tunnel) is loose. The screw is not fixed in the hole. It seems it was badly fixed while assembling the car and they had applied to much power thus destroying the winding.I could easily take the screw out!
As a result I have sometimes contact problems, that disables starting the car or missing sparks (?).

1. It is very hard to operate at this area because there is no room left and the carpet is very close to the point. What can I do? Is there some trick to make fixing the screw easy without taking of the tunnel cover, carpet,etc?

2. Besides I would like to connect a new earthing cable between this point and the battery (-) and just hide it under the carpet - advisable, necessary, alternative?

3. I would like to connect a new earthing cable from the battery minus to the engine through a little drilling hole from the passenger´s footwell into the engine bay. there is e.g. a plate somewhere near the flowmeter. Why?
Whenever there is a starting problem, I could restart with a starter cable between battery minus and that place.

Thank you for your help!

Michael






Al 450

1,390 posts

252 months

Monday 27th April 2009
quotequote all
It's true that there is no harm in adding extra earths although you should not need it if the car was assembled correctly.

Why don't you just remove the mis-threaded screw and either tap the hole with a thread cutter or drill the hold out larger and tap it with a bigger thread? It's got to be easier than adding extra earths under the carpet.

Vienna TVR

Original Poster:

89 posts

231 months

Tuesday 28th April 2009
quotequote all
Hi Al 450,

to use a thread cutter is a good idea and seems to be the simplest remedy.

Yesterday I found out, that in case of starting failure I only held my fingers on top of the screw placing it to have the ideal contact (or is it rather no contact?) and I could start. This was much less effort than placing a starter cable from battery minus to the engine bay start and put the cable back. I wonder what happens if I do that when the engine is running!

Michael

Edited by Vienna TVR on Tuesday 28th April 06:59