Discussion
My seat had two 'square tubing' sections which fitted between the seat rails and the floor to lift the front of the seat upwards (also tilting it slightly backwards) which I found uncomfortable (my guess it was for someone much taller than me) and I moved them to the rear, so as to tilt the seat slightly forward (I'm 5'9"). Not sure if all cars have these ?
PM me if you'd like a chat .. hard to describe on here. You anywhere near Poole (Dorset) ?
PS : don't forget you can easily extend the pedals.
PM me if you'd like a chat .. hard to describe on here. You anywhere near Poole (Dorset) ?
PS : don't forget you can easily extend the pedals.
Hi Duncan
Thanks for that. Agree entirely about the angle being uncomfortable - the seat actually feels like it's tilted slightly backwards, & the front edge 'cuts' into the back of my legs.
Not had a look under the seats properly yet & no, not near Poole I'm afraid.
It's not reaching the pedals I have the problem with (although I admit the seat is pretty much as far forward as it will go !), it's the impression that I'm looking along the top of the bonnet !
I have to travel along a pretty rough & potholed track each week, & I find I have to lift my a**se out of the seat to spot the holes before I drive into them !! Sad isn't it ?
Chris
Thanks for that. Agree entirely about the angle being uncomfortable - the seat actually feels like it's tilted slightly backwards, & the front edge 'cuts' into the back of my legs.
Not had a look under the seats properly yet & no, not near Poole I'm afraid.
It's not reaching the pedals I have the problem with (although I admit the seat is pretty much as far forward as it will go !), it's the impression that I'm looking along the top of the bonnet !
I have to travel along a pretty rough & potholed track each week, & I find I have to lift my a**se out of the seat to spot the holes before I drive into them !! Sad isn't it ?
Chris
Guys,
Would be really interested in hearing about this.
Whilst I don't have any issues as the driver my partner is only 5'1" and so in the passenger seat she just gets a nive view of the wipers.
Would like to do a similar thing on the passenger side - haven't checked the bolt lengths yet but was plenning on hopefully putting some spacer underneath to raise it an inch or two.
Can you let us know what you find and any solutions you think up?
Cheers
Ben
Would be really interested in hearing about this.
Whilst I don't have any issues as the driver my partner is only 5'1" and so in the passenger seat she just gets a nive view of the wipers.
Would like to do a similar thing on the passenger side - haven't checked the bolt lengths yet but was plenning on hopefully putting some spacer underneath to raise it an inch or two.
Can you let us know what you find and any solutions you think up?
Cheers
Ben
I extended my passenger side by using copper tubing (obvious cut the length/extra height I required), extended stainless bolts and nuts (nyloc) with 52mm washers(penny washers, stainless as well), either side of the copper pipes and under the floor.
Simple to do in my humble opinion - a bit of measuring, planning and no need for "a kit" !!
Trev
Simple to do in my humble opinion - a bit of measuring, planning and no need for "a kit" !!
Trev
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


