Fuel Pump Relay - wonder why they fail?
Fuel Pump Relay - wonder why they fail?
Author
Discussion

fenderbender

Original Poster:

339 posts

255 months

Sunday 3rd May 2009
quotequote all
I know there are lots of posts about the fuel pump relay, but I thought I would share my experience.

Chim was properly set up for overwinter storage last year (not just driven into a lockup and forgotten!). When it went into the garage in late November the engine ran like a sewing machine. When I came to start it last weekend (after 3 months) the fuel pump would not kick in. I swapped the relay straight away and - naturally - the car fired up first time and has been fine since.

Now what intrigues me is why a relay would fail during storage? My general experience of Bosch components is that they are likely to outlive the car they are fitted to...

nawarne

3,181 posts

291 months

Sunday 3rd May 2009
quotequote all
fenderbender said:
I know there are lots of posts about the fuel pump relay, but I thought I would share my experience.

Chim was properly set up for overwinter storage last year (not just driven into a lockup and forgotten!). When it went into the garage in late November the engine ran like a sewing machine. When I came to start it last weekend (after 3 months) the fuel pump would not kick in. I swapped the relay straight away and - naturally - the car fired up first time and has been fine since.

Now what intrigues me is why a relay would fail during storage? My general experience of Bosch components is that they are likely to outlive the car they are fitted to...
All IMVHO of course, but my take on this 'issue' is that they are allowed to 'flop' about on the flying leads, they are tucked up against a hot bulkhead and can/are subject to humidity/damp in cars that are not very watertight - - if you can ever call a convertible watertight.

Having said all the above, I've not had this problem with my Chim, but it was tended to be an issue on my V8S.

Nick

GreenV8S

31,027 posts

315 months

Sunday 3rd May 2009
quotequote all
Every time a switch or relay is operated it cleans the contacts slightly. If you leave it unused for a while there's time for surface corrosion to build up on the contacts so quite likely you'll encounter new problems when you come to use it again. Leaving cars laid up is not generally good for them.

spend

12,581 posts

282 months

Sunday 3rd May 2009
quotequote all
Check whether it was the contacts that failed or the diode across the coil? Those relays have a continuous power supply wink